FIAMMA 98655Z166, 98655Z167 Adapter Ford Transit Brackets Instruction Manual
- June 1, 2024
- FIAMMA
Table of Contents
FIAMMA 98655Z166, 98655Z167 Adapter Ford Transit Brackets
Specifications
- Product: Brackets
- Model: F80 / F65
- Compatibility: Ford Transit H2 L2 / L3
- Dimensions: 125mm x 52mm (Adapter), 169mm x 231mm (Bracket)
Package Contents
Check that nothing has been damaged or deformed during transport before
starting the installation process.
Installation Instructions
- Before installation, ensure that the antenna position on the vehicle is checked.
- Ensure the adapter is mounted linearly without any curves or deformations due to the vehicle. If needed, shim appropriately for alignment.
- Use SIKA 252 adhesive for fixing the brackets securely.
- Tighten the screws firmly to ensure a secure installation.
- Remove the security label only after fixing the awning on the adapter.
Safety Warnings
If you have any doubts or questions regarding the installation, use, or
limitations of the product, contact the dealer for assistance.
FAQ
-
Q: Can I install the brackets without using SIKA 252 adhesive?
A: No, it is essential to use SIKA 252 adhesive for fixing the brackets securely.
Q: What should I do if the adapter is not mounted linearly? -
A: If the adapter is not mounted linearly, shim appropriately to ensure alignment before installing the awning.
Installation instructions for brackets
FORD TRANSIT H2 L2 / L3
98655Z166 98655Z167
F80 / F65 (L2 – 290 cm)
F80 / F65 (L3 – 320 cm)
FIAMMASTORE
Check the position of the antenna on the vehicle before installation
Check that nothing has been damaged or deformed during transport. In the event of doubts or questions concerning the installation, use or limitations of the product, contact the dealer. Have the installation carried out by qualified personnel and in accordance with local regulations.
ATTENTION: INSTALLATION ON ADAPTER
Ensure that the adapter is mounted linearly and not present curves or
deformation due to the vehicle: in these cases, shim appropriately to ensure
the linearity of the bracket. The installation of the awning can occur only
when the adapter is perfectly aligned to the wall of the vehicle.
When using the awning please follow the instructions of the product.
ATTENTION Periodically check the brackets to make sure they are firmly attached (especially after the first kilometers) make sure the bolts are not loose and that holding brackets have not shifted.
Read the following instructions and warnings carefully; failure to observe
these installation and usage instructions as well as the laws for driving in
the relevant country may cause severe harm or damage for which the
manufacturer declines all responsibility.
Before installation, ensure compatibility with the vehicle on which the
product must be installed. Checking that the wall/roof/rear door is
sufficiently solid and suitable for guaranteeing the resistance of the
anchoring points is always mandatory. If not, strength and compliance with the
maximum load indicated in the instructions are not guaranteed and it will be
necessary to reinforce it these points.
In the event of an accident involving the vehicle and/or the product, ensure that the product has not been damaged. In the event of damage, contact your local retailer before moving the vehicle. Fiamma declines every responsibility for any modification of the product that may cause damage and/or injury to things and people.
Warranty Fiamma
In case of defects with regards to materials and manufacturing, the customer is entitled to the warranty in accordance with local laws and regulations of the country in which the product was purchased.
Fiamma S.p.A. – Italy
Via San Rocco, 56
21010 Cardano al Campo (VA)
All rights reserved.
Fiamma S.p.A.
reserves the right to modify at any time, without notice, prices, materials,
specifications and models or to cease production of any model.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>