JESLED T8 G13 LED Tube Installation Guide
- June 15, 2024
- JESLED
Table of Contents
8 G13 LED Tube Installation
Installation Warning !!!
- Remove or disconnect ballasts and starters before installation! Failure to do so will cause irreparable damage to your new LED tube and could cause a fire!
- Rewiring of fluorescent fixtures for use with LED tubes should only be performed by individuals who have been properly trained to perform basic electrical maintenance and repair. Please review these instructions thoroughly before proceeding!
How to install this led tube?
Step 1:
Before opening and disassembling the fixture, make sure power has been turned
off at the main circuit breaker and remove the bulbs from the fixture.
Step 2:
Open your fixture and examine the wiring. You will see either Electronic
Ballast or Magnetic Ballast in your fixture. The wiring diagram for a typical
fluorescent fixture using single-pin, stationary /plunger-type sockets is
shown below step 3 . Although configurations may vary, the basic concept
is the same. If you have a different wiring fixture, please contact us to
support@jesled.com.
Step 3:
Remove or bypass the ballast indicated in the diagram below: cut or
disconnect the wires in the locations indicated. Try to leave enough wire to
allow rewiring of the sockets to the line and neutral as shown in the diagram
in step 4.
Step 4:
Connect the Live wire to one side (the single-wire plunger sockets) and
connect the Neutral wire to other side (the double-wire stationary sockets) as
shown below. Make sure all wire connections are wire nutted and wrapped with
electrical tape, and make sure the fixture is properly grounded before
reassembling the fixture.
Step 5:
Install your new LED tubes in the fixture.
Manufacturer: Dong Guan City Shengwei Lighting Co., Ltd
MADE IN CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>