FLOS F4682009 Oplight W2 LED Dimmable Wall Lamp Instruction Manual
- June 3, 2024
- FLOS
Table of Contents
FLOS F4682009 Oplight W2 LED Dimmable Wall Lamp Instruction Manual
INSTRUCTION FOR CORRECT INSTALLATION AND USE WARNING!
The safety of this fitting can only be guaranteed if these instructions are
observed, during both installation and use. Please retain these instructions
safety.
REMARKS:
- When installing and whenever acting on the appliance, ensure that the power supply has been switched off.
- The appliance may in no way be modified or tampered with. Any modification may compromise safety and making the appliance itself dangerous. FLOS declines all responsibility for products that are modified.
- This appliance must be connected to an efficient grounding system in order to work safely and correctly.
- The device carries no risk of photobiological emissions.
- The light source cannot be replaced by the customer. Contact FLOS for information.
- The device’s light intensity can be adjusted using commercially available dimmers (see the list of compatible dimmers included inside the package).
- The symbol shown on the device indicates that the product must be disposed of in a different manner than with the urban waste.
TECHNICAL DATA
W1 16W LED.
W2: 25W LED.
CLEANING INSTRUCTIONS
- Use only a soft cloth to clean the appliance, dampened with water and soap or mild cleanser if needed for resistant dirt.
- Warning: do not use alcohol or other solvents.
Pic.3a/3b NOTE: Select and employ screw anchors which are suited to the surface where the appliance is to be installed.
List of dimmers compatible with OPLIGHT W1/W2 EUR/USA
It is possible to adjust the light intensity of this product with some TRIAC dimmers available in the market. FLOS recommends the following dimmers:
In an effort to support our Customers in choosing a suitable dimmer to use to
adjust the light flow of our Olight W, we have checked its operation with some
of the dimmers available on the market. The checks were performed with the
power supply “controlled” (stabilised voltage, sinusoidal waveform, etc.); use
of the Oplight W device in real operating conditions could be subject to
specific variables relating to the environmental ambient conditions in the
specific installation ( power supply conditions, interference in the mains
network, interference caused by connection of other devices to the mains
network). The real operating conditions could be different to those
encountered during the tests depending on any changes made by manufacturers to
the specific dimmers and also depending on the tolerances of the electronic
components used on the card inserted in the Oplight W device.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>