FLOS F5400009 Parentesi Floor Lamp Instruction Manual
- June 6, 2024
- FLOS
Table of Contents
FLOS F5400009 Parentesi Floor Lamp Instruction
INSTRUCTION FOR CORRECT INSTALLATION AND USE
WARNING!
The safety of this fitting can only be guaranteed if these instructions are
observed, during both installation and use. Please retain these instructions
safety.
REMARKS:
- When installing and whenever acting on the appliance, ensure that the power supply has been switched off.
- The appliance may in no way be modified or tampered with, any modification may compromise safety causing the appliance to become dangerous. FLOS declines all responsibility for products that are modified.
- Should the external trailing cable get damaged,it must be replaced by FLOS or by qualified personnel in order to avoid any danger.
- The symbol marked on the appliance indicates the minimum distance at which the subject to be illuminated should be placed.
- The symbol shown on the device indicates that the product must be thrown out in a different manner than with the urban trashes.
- WARNING: Raising the counterweight (Fig.7) will cause loss of mechanical tension in the suspension wire and the lamp support will fall.
TECHNICAL DATA
- EUR: Incandescent light bulb MAX 105W, E27 fitting, IRR D125 type.
- USA: Incandescent light bulb MAX 150W, E26 fitting, R40 FLOOD.
CLEANING INSTRUCTIONS
-
Use only a soft cloth to clean the appliance, dampened with water and soap or mild cleanser if needed for resistant dirt.
-
Warning: do not use alcohol or other solvents.
-
Pic.1 EUR NOTE: Select and employ screw anchors which are suited to the surface where the appliance is to be installed.
-
Pic.10 INSTALLATION OF EXTRA PIECE To install the extra piece refer to figures 3, 4, 5 and 6.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>