NITECORE Headlamp Mate User Manual
- June 7, 2024
- Nitecore
Table of Contents
NITECORE Headlamp Mate User Manual
Features
- Lightweight and tiny warning light
- Utilizes 4 high performance LEDs
- Dual white and red light sources
- Built-in rechargeable Li-ion battery with max runtime up to 20 hours
- Built-in intelligent Li-ion charging circuit for Micro-USB charging
- Simple one switch control for one-handed operation
- 4 special modes selectable
- Built-in power indicator to indicate remaining power level (Patent NO.: ZL201220057767.4)
- Constructed from durable and sturdy PC material
- Ultra-lightweight design for extreme portability
- 1 meter impact resistance
Specification
Size: 29.5mm×30.3mm×16.3mm (1.16”×1.19”×0.64”)
Weight: 10.4g (0.37oz)
Accessory
Simple edition: No additional Headlamp band, USB cable,
NU05 kit: accessories bike mounts
Brightness & Runtime
|
Red Indicator (slow blink)
|
Red (slow blink)
|
Red (quick blink)
|
White (slow blink)
|
White Light Illumination
---|---|---|---|---|---
Output
|
—
|
4 lumens
|
4 lumens
|
35 lumens
|
35 lumens
Runtime
|
20h
|
9h
|
9h
|
2h 15min
|
1h
1 meter (Impact resistance)
IP66 (Dustproof and waterproof)
NOTE: The stated data has been measured with NU05 built-in Liion battery (3.7V 120mAh). The data may vary during real-world use due to different environmental factors.
Operating Instruction
ON/OFF
Turn on: Tap the switch once to turn on the NU05 and the red indicator will
blink slowly.
Turn off: If no further operation occurs 3 seconds after turning on, tap the
switch once again to enter standby status. When the NU05 is fully charged, the
max standby time up to 1 year theoretically.
Mode Selection
NU05 has 4 special modes and white light illumination. Within 3 seconds
interval, press the switch repeatedly to cycle through Red Indicator (slow
blink) – Red Light (slow blink) – Red Light (quick blink) – White Light (slow
blink) – White Light Illumination – Standby.
Lockout/unlock
Lockout: When the light is on, hold the switch for one second to lockout;
after lockout, the indicator will blink once to notify user.
Unlock: In lockout status, hold the switch for three seconds, the NU05 will
unlock and then enter the Red Indicator (slow blink).
Charging
- The NU05 has a USB charging port. As shown in the diagram, open the rubber cover of the USB port, plug the end of the USB cable into the port and the other end to the power source (adapter, computer or other power devices) to charge. It takes about 2 hours to fully charge NU05.
- Power tip: A red indicator will turn on during charging. Upon completion red indicator light will turn green.
Power tips
In standby status, hold the switch for one second, the indicator will blink to
indicate the power level:
3 blinks indicate the power level is above 50%
2 blinks indicate the power level is below 50%
1 blink indicates the power level is close to depletion
NOTE: When the power level is insufficient, the NU05 will dim and should
be charged before further use.
Warranty Service
All NITECORE® products are warranted for quality. DOA/defective products can
be exchanged for replacement through a local distributor/dealer within the 15
days of purchase.
After 15 days, all defective / malfunctioning NITECORE® products will be
repaired free of charge for a period of 24 months from the date of purchase.
After 24 months, a limited warranty applies, covering the cost of labor and
maintenance, but not the cost of accessories or replacement parts. The
warranty is nullified in all of the following situations:
- The product(s) is/are broken down, reconstructed and/or modified by unauthorized parties.
- The product(s) is/are damaged through improper use.
※ For the latest information on NITECORE® products and services, please contact your national NITECORE® distributor or send an email to service@nitecore.com. The Nitecore official website shall prevail in case of any product data changes.
Worldwide Warranty Service
Model number__ Date of purchase
Serial number Store Stamp __
This is the certificate of authenticity if this item and we confirm that it
has been subjected to the most exacting quality controls by SYSMAX Innovations
Co., Ltd.
NOTE:
Please ensure this warranty card is fully completed by the distributor or
retailer after purchasing the product. Should the product fail to operate
correctly during the warranty period, it may be returned with the completed
warranty card and original sales receipt to the retailer or local distributor
for replacement or repair.
Customer Service Email: service@nitecore.com
Contact Info
SYSMAX Innovations Co., Ltd.
TEL: +86-20-83862000
FAX: +86-20-83882723
E-mail:
info@nitecore.com
Web: www.nitecore.com
Address： Rm 2601-06, Central Tower, No.5 Xiancun Road, Tianhe District,
Guangzhou,510623, Guangdong, China
Thanks for purchasing NITECORE!
Documents / Resources
|
NITECORE Headlamp
Mate
[pdf] User Manual
Headlamp Mate, nu05
---|---