FLOS 03.6296.14 Running Magnet String Light Module Instruction Manual
- June 6, 2024
- FLOS
Table of Contents
FLOS 03.6296.14 Running Magnet String Light Module
INSTRUCTIONS OF INSTALLATION AND USE
ATTENTION!
The safety of the device can only be guaranteed on condition that to be
respected the following instructions, both stages of installation and use
therefore ii is highly recommended to keep them.
WARNING:
To carry out the installation, and whenever an operation in the device is
carried out, make sure of having disconnected the electric power. The device
cannot be in any case modified or forced, any modification might jeopardize
the safety system making ii dangerous. FLOS declines any responsibility on
modified products. The device has been designed for inside. IP20 Ordinary.
Luminaire kind Ill: Device with a very low tension of safety. The conformity with the standard is only guaranteed if the device is powered by a safety transformer according to the standard Cenelec EN 604472 or by equal safety sources. Devices with a very low voltage of safety (BTS) marked, do not O have to be connected to drivers with earth socket.
If the flexible cable or cord of this luminaire is damaged, ii should be exclusively replaced by the manufacturer or his technical service or a qualified g person in order to avoid any risk.
TECHNICAL DATA
Lighting device of the Group of risk 1: Low, according to the standard EN 62471:2008
The symbol shown on the device indicates that the product must be eliminated differently from the rest of the urban waste.
CLEANING INSTRUCTIONS
Use only a soft cloth to clean the appliance, dampened with water ans soap or
mild cleanser if needed for resistant dirt.
Warning: do not use alcohol or other solvents. Connect the mains cables
to the remote power supply unit SELV or SELV EQUIVALENT in according to the
law EN 61347-2-13, respecting the right polarity (red positive – black
negative)
Luminaires intended for direct assembly on surfaces that are normally
flammable.
- The symbol marked on the device indicates the replacement of the damaged protection screens using exclusively original FLOS spare parts. Do not use the luminaire without glass.
- Do not use the luminarie without glass. In case of glass breakage, contact the manufacturer for a replacement.
TECHNICAL DATA
STRING LIGHTS
NO DALI VERSION
MAX g String light each profile using a 185W driver.
WARNING
Only use with the electrical supply track system:
” The Running Magnet System ”
LUMINAIRE INSTALLATION
OPTION ONE
OPTION TWO
EXAMPLE
CASAMBI VERSION
- -The CASAMBI control will be 1% to 100%
- MAX. 200 luminaries for a single CASAMBI network.
- MAX. 15 meters between luminaires if the environment is an open space ( no wall in between luminaires)
- To know more about all CASAMBI optiions visit www.casambi.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>