FLOS ARCHITECTURAL Light Shadow PRO Installation Guide
- June 3, 2024
- FLOS ARCHITECTURAL
Table of Contents
FLOS ARCHITECTURAL Light Shadow PRO
INSTRUCTIONS OF INSTALLATION AND USE
ATTENTION!
The safety of the device can only be guaranteed on condition that to be
respected the following instructions, both stages of installation and use
therefore it is highly recommended to keep them.
WARNING:
To carry out the installation, and whenever an operation in the device is
carried Out, make sure of having disconnected the electric power. The device
cannot be in any case modified or forced, any modification might jeopardize
the safety system making it dangerous. FLOS declines any responsibility on
modified products.
- The device has been designed for inside.
- P20 Ordinary.
- IP X4 Protected aga
- IP 5X Protected against penetration of dust water splash
- Class I luminaire: Device with a very low safety voltage. Connect the main cables to the remote led power supply SELV under the EN 61347-2-13 standard, respecting the right polarity (red positive black negative). Devices with a very low safety voltage showing the (BTS) mark should not be connected to earthing conductors.
- Luminaires intended for direct assembly on surfaces that are normally flammable.
- Under no circumstances should the luminaire be covered with insulating or similar material.
- If the flexible cable or cord of this luminaire is damaged, it should be exclusively replaced by the manufacturer or his technical service or a qualified person in order to avoid any risk.
- Use appropriate equipment in agreement with the standard.
- The luminaire should only be used with Flos accessories or components.
CLEANING INSTRUCTIONS
Use only a soft cloth to clean the appliance. For stubborn dirt, dampen the cloth with water and clean only the reflector and the outer part of the appliance. Do not clean or touch the LED/light source in any way. Warning: do not use alcohol or other solvents. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person. Please refer to the product label to check the electrical specifications
RECESSING DIMENSIONS
NO TRIM
NO TRIM FIX
NO TRIM ADJUSTABLE
TO REMOVE
TRIM
TRIM FIXED
TRIM ADJUSTABLE
TO REMOVE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>