RAB ORB4, ORB6 Fully Luminous Canless Downlight Installation Guide

: September 27, 2024
: RAB

Table of Contents

RAB ORB4, ORB6 Fully Luminous Canless Downlight
WHAT’S IN THE BOX
TOOLS NEEDED
OPTIONAL ACCESSORIES
OPTIONAL ACCESSORIES (contd)
INSTALLATION INTRODUCTIONS
Read User Manual Online (PDF format)
Download This Manual (PDF format)

RAB ORB4, ORB6 Fully Luminous Canless Downlight

RAB Lighting is committed to creating high-quality, affordable, well-designed, and energy-efficient LED lighting and controls that make it easy for electricians to install and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: marketing@rablighting.com

IMPORTANT
READ CAREFULLY BEFORE INSTALLING THE FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE. RAB fixture must be wired by the National Electrical Code and all applicable local codes. Proper grounding is required for safety. THIS PRODUCT MUST BE INSTALLED by THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED. TO PREVENT ELECTRICAL SHOCK, POWER SHOULD BE TURNED OFF AT THE FUSE BOX BEFORE INSTALLATION.

SAFETY WARNINGS
Read all product labels and directions.

WARNING – Risk of fire or electric shock. Install this kit only in the luminaires that have the construction features and dimensions shown in the photographs and/or drawings and where the input rating of the retrofit kit does not exceed the input rating of the luminaire.
Installation should be performed only by a qualified electrician by the National Electrical Code and relevant local codes. Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
WARNING – To prevent wiring damage or abrasion, do not expose wiring to the edges of sheet metal or other sharp objects.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

WHAT’S IN THE BOX

RAB-ORB4-ORB6-Fully-Luminous-Canless-Downlight-fig-1

TOOLS NEEDED

This Frameless Edge-Lit Wafer requires very few tools for installation. A screwdriver and a pair of wirecutters will help to install.

OPTIONAL ACCESSORIES

RAB-ORB4-ORB6-Fully-Luminous-Canless-Downlight-fig-2

OPTIONAL ACCESSORIES (contd)

INSTALLATION INTRODUCTIONS

Turn the power OFF from the electrical panel before installation.
Use the template inside the box to cut holes in the ceiling. (Fig. 1)
Open the driver box and remove the knockout(s). (Fig.2)
Insert the electrical supply cable through the knockout and secure it with a strain relief or cord clamp. Wire driver box (Fig.3), white-white, black-black, green-green/ground.
Place all wiring and connections back into the box, close the cover, and select the desired CCT. (Fig.4)
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation, operation, or maintenance.
INSTALLATION INTRODUCTIONS (contd)
Place the driver box into the ceiling and connect the fixture to the driver box. (Fig.5)
Lifting both retention tabs upward, push until the trim sits flush against the ceiling. (Fig.6)