kogan KAARTV65NBA Artistic Solid Wood Floor Stand with Shelf Owner’s Manual

: September 19, 2024
: Kogan

Table of Contents

SAFETY & WARNINGS
COMPONENTS
ASSEMBLY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

USER GUIDE ARTISTIC SOLID WOOD
FLOOR STAND WITH SHELF
SUITABLE FOR 45″-65″ TVS
KAARTV65NBA

SAFETY & WARNINGS

Failure to read, thoroughly understand and follow all instructions can result in serious personal injury or property damage. If you have any questions regarding any of the instructions or warnings, contact help.Kogan.com for support.
Ensure that the mounting surface is strong enough to handle a mounted product and equipment.
DO NOT EXCEED THE MAXIMUM LISTED WEIGHT CAPACITY.
Always use an assistant or a mechanical lifting device to safely lift and position heavy products.
Tighten screws firmly, but do not over tighten. Over tightening can cause product damage that greatly reduces the holding power.
Keep a clear area and distance from moving parts when using the product.
Use only as intended. Never stand, hang or climb on the product.
This product is intended for indoor use only. Any attempts to reconstruct the product are not permitted. This product may contain small items that could be a choking hazard if swallowed. Keep children away unless the product is intended for their use and all instructions are fully reviewed and understood by them.
Check that the product is secure and safe to use at regular intervals (at least every three months).
This product includes safety kits that must be used in conjunction with the product to prevent the product from falling or tipping over. Follow the enclosed information to properly install these safety accessories.

COMPONENTS

ASSEMBLY

Step 1:
Using the Allen key (M), secure the shelf (A) to the stand (D) using the M6x60 screw (K) and x2 M6x30 screws (J).
Step 2:

Using the Allen key (M), secure the front legs (F) to the shelf (A) using x2 M6x30 screws (J).
Using the Allen key (M), secure the rear leg (E) to the shelf (A) using the M6x90 screw (L).

Step 3:

Using the Allen key (M), loosen the screw on the locking collar (G). Move the locking collar (G) into the required position and tighten the screw using the Allen key (M).
Secure the locking collar (G) before attaching the TV.
Ensure the screw hole is facing the back.

Step 4:
Loosen the screw on the lower bracket (C) to open the clasp. Step 5:

Attach the brackets (B & C) to the rear of the TV and secure them in place using the supplied screws (‘M-’ set) and washers (M-E).
The x2 cable clips (P-B) must be attached to the upper bracket (B).
Note: Depending on your TV you may need to install the spacers (M-F & M-G).

Step 6:

Carefully attach the TV to the stand. Enlist the help of a second person to safely carry the TV.
Close the clasp on the lower bracket (C) and tighten the screw.

Attach the x2 cable clips (H) to the TV stand using the x2 ST4.2×12 screws (I). Then, route the cable. Step 7:

To avoid the TV falling, it is highly recommended to install the anti-fall hardware.
Mark the desired position for the anti-fall bracket (P-C). For drywall or plaster, use a stud finder.
Drywall / plaster: Drill a pilot hole using a 3.5mm drill bit and drill.
Masonry / concrete: Drill a pilot hole using a 7mm drill bit and drill.

Step 8:

Drywall / plaster: Secure the anti-fall bracket (P-C) to the wall using the ST4.8×38 screw (P-E).
Masonry / concrete: Secure the anti-fall bracket (P-C) to the wall using the wall anchor (P-F) and ST4.8×38 screw (P-E).

Step 9:
Using the anti-fall rope (P-A), x2 cable clips (P-B) and x2 rope screws (P-D) secure the TV to the wall.
Note: Ensure there is enough tension on the rope so that the TV will not tip over. NOTES

Need more information?
We hope that this user guide has given you the assistance needed for a simple set-up.
For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.com