ORTECH SLIM4DGR-5CCT LED Slim Lights Instruction Manual
- June 4, 2024
- Ortech
Table of Contents
ORTECH SLIM4DGR-5CCT LED Slim Lights
WARNING
THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
- LED Slim Lights are suitable for indoor use only.
- DO NOT use outdoors
- Please keep the LED Slim Lights away from any corrosive substance, and please use dry cloth when you clean them
- LED Slim Lights can only be installed by a qualified electrician.
- Before installation or maintenance, please disconnect the power to prevent electric shock.
Application Notice
- For your safety, this fixture MUST be wired in accordance to local electrical codes and ordinances
- Turn power off from the electrical panel before starting installation or attempting any maintenance.
- Indoor installation only.
CAUTION
Electrical products can cause death or injury, or damage to property. If in
any doubt about the installation or use of this product, consult a competent
electrician.
Tools Required
- Saw
- Measuring Tape
- Electrical Wiring use type and gauge suitable for application to connect the fixtures.
Driver Wiring
- Open the hardwire box swing cover and remove the appropriate knockout
- Insert the electrical supply cable through the knockout and secure with a cable connector separately.
- Using wire nuts, connect GREEN ground wire of cable to GREEN wire on box.
- Connect WHITE wire of cable to WHITE wire of box.
- Connect BLACK wire of cable to BLACK wire of box.
- Place all wiring and connections back into the box and close the cover.
- Insert hardwire box through the mounting hole.
New Construction Applications
Hardwire box shall be firmly secured to studs, joists, or similar fixed structural units.
Remodel Applications
DO NOT require the hardwire box to be firmly secured after the mounting plates, studs, joists, or structural units have been concealed.
Pre installation
- Turn power OFF from the electrical panel before starting installation.
- Locate a suitable position to plate the fixture and open in accordance to the cut-hole dimensions.
- Run electrical wire from the switch power supply through the mounting hole use NMD90 Romex or BX cable.
INSTALLATION GUIDE
Fixture Installation
- Connect the fixture to the hardwire box by inserting and twisting the male / female connectors.
- Select desired colour temperature using the selector button at the back of the fixture preset to 3000K warm white.
- Push spring loaded clips on the fixture upwards and insert fixture base into the mounting hole.
- Release the clips and fixture will be pulled flush to the ceiling.
- Once assembly is complete, turn ON power to confirm that fixture is working properly.
Compatible Dimmer List
ORTECH reserves the right to modify at any time, without notice, any or all of our product’s features, designs, components and specifications to meet market changes.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>