Caterlite CN515-A Vacuum Pack Machine Instruction Manual

: September 12, 2024
: Caterlite

Table of Contents

Caterlite CN515-A Vacuum Pack Machine
FAQs
Safety Instructions
Introduction
Pack Contents
Location of Controls
Operation
Vacuum Packing Food
Cleaning, Care & Maintenance
Troubleshooting
Technical Specifications
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Caterlite CN515-A Vacuum Pack Machine

CaterliteCN515-A-Vacuum-Pack-Machine-PRODUCT

FAQs

Q: What should I do if my machine is not sealing bags correctly?

A: If your bags are not sealing correctly, it is recommended to have a qualified technician inspect and repair the machine as needed.

Safety Instructions

Position on a flat, stable surface.
A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components from this product.
Consult Local and National Standards to comply with the following:
- Health and Safety at Work Legislation
- Fire Precautions
- Wiring Regulations
- Building Regulations
DO NOT immerse the appliance in water.
The sealing bar becomes hot during use. DO NOT touch the sealing bar during or immediately after the operation.
Do not turn Off the plug to halt operation; always use the Cancel button.
Do not use the appliance for anything other than its intended use.
Only use bags recommended by the supplier/manufacturer with the appliance.
Always switch off and disconnect the power supply to the appliance when not in use.
Not suitable for outdoor use.
Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities.
If the power cord is damaged, it must be replaced by a Caterlite agent or a recommended qualified technician in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience or knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Caterlite recommends that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Insulation Continuity, and Functional Test.

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your Caterlite product.

Pack Contents

The following is included:

Caterlite Vacuum Pack Machine
Instruction manual

Caterlite prides itself on quality and service, ensuring that at the time of unpacking the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your Caterlite dealer immediately.

Location of Controls

$CaterliteCN515-A-Vacuum-Pack-Machine-FIG- $1$$ $CaterliteCN515-A-Vacuum-Pack-Machine-FIG- $2$$

Operation

The Vacuum Pack Machine automatically comes on when plugged in.
The Vacuum Pack Machine is now ready for use.

Vacuum Packing Food

Place the food in the bag and remove any excess liquid or food residue.
Allow a minimum of 25-50mm of space at the top of the bag to ensure a good seal.
Place the open end of the bag across the Sealing Strip, keeping the opening within the chamber ring, and close the lid, pressing down with your thumbs until the locks on both sides engage.
Press the “Vacuum Seal” button. The indicator light will turn red.
The vacuum pump will engage until the required vacuum level is achieved. The machine will automatically go into seal mode.
Seal Only indicator light will turn red as the machine starts to seal.
When sealing is complete red Seal Only light will go out. Press the side lock buttons to release the lid.
Remove the bag and inspect the bag and seal.
- (Note : A good seal will look clear upon inspection. If the seal is spotty, incomplete, wrinkled, white, or milky, remove the sealed portion and run the vacuum and seal process again.)
To stop process, press “Cancel” button. Machine will stop.

Using the “Seal Only” Function

Place the open end of the bag across the Sealing Strip, keeping the opening within the chamber ring, and close the lid, pressing down with your thumbs until the locks on both sides engage.
Press the “Seal Only” button.
The indicator light will change to red as the machine starts to seal
When sealing is complete red Seal only light will go out. Press the side lock buttons to release the lid.
Remove bag and inspect the bag and seal.
- (Note: A good seal will look clear upon inspection. If the seal is spotty, incomplete, wrinkled, white, or milky, remove the sealed portion and run the vacuum and seal process again.)

Cleaning, Care & Maintenance

Switch off and disconnect from the power supply before cleaning. Always allow it to cool before cleaning.

WARNING: Do not allow any water to spill into the appliance when cleaning.

Use warm, soapy water and a damp cloth to clean the appliance.
Dry thoroughly after cleaning.

Troubleshooting

A qualified technician must carry out repairs if required.

Fault	Probable Cause	Solution
The appliance is not working	The unit is not switched on	Check the unit is

plugged in correctly and switched on
Plug or lead is damaged| Replace plug or lead
Mains power supply fault| Check the mains power supply
Appliance does not remove all the air from the bag| The open end of the bag not completely inserted| Open the lid and reposition the bag
Gaskets dirty| Clean gaskets
The open end of the bag is dirty| Clean bag
The bag may be punctured| Replace bag
Incorrect bags used| Call the Vacuum Pack machine supplier
Suction nozzle blocked| Clear suction nozzle
Lid is not locked into position correctly| Ensure the lid is locked in position correctly
Bags are not sealing correctly| Moisture in a bag under the sealing bar| Ensure the inside of the bag is dry and free from moisture where it is to be sealed
Incorrect bags used| Call the Vacuum Pack machine supplier
End of the bag is not placed above the sealing bar| Move the end of the bag over the sealing bar

Technical Specifications

Note : Due to our continuous improvement process, the product specifications are subject to change without notice.

Model| Voltage| Power| Current| Vacuum Pressure (approx.)| Dimensions h x w x d mm| Weight (kg)
---|---|---|---|---|---|---
CN515- A| 220-240V~

50Hz

| 110W| 0.5A| -0.75 Bar| 87 x 357 x 148| 1.4

Electrical Wiring

The plug is to be connected to a suitable main socket. This appliance is wired as follows:

Live wire (colored brown) to the terminal marked L
Neutral wire (colored blue) to the terminal marked N
Telephone Helpline: 1300225960

If in doubt consult a qualified electrician. Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required, they must be readily accessible.

Compliance

The product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.

Caterlite parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities. Caterlite products have been approved to carry the following symbol:All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of Caterlite. Every effort is made to ensure all details are correct at the time of going to press, however, Caterlite reserves the right to change specifications without notice.

DECLARATION OF CONFORMITY