Lumens HDL410 Cam Connect Pro User Guide

Table of Contents

Q: How often should I recalibrate my HDL410?

A: Recalibrate your HDL410 whenever there are room-level changes to ensure optimal performance.

Q: Where can I find the HDL410’s IP address?

A: The IP address of the HDL410 can be found in the CamConnect Pro settings as well as during the enrollment process.

Q: Do I need to adjust room dimensions for dual HDL410s?

A: Dual HDL410s work as a single unit, so defining room dimensions accurately is crucial for optimal performance.

Nureva HDL410 & CamConnect Pro Settings Guide

Discovering / Enrolling HDL410

Access the Nureva console: https://www.nureva.com/software-and-services/console You can connect over USB or using a browser (shown here). If you are using USB, click here for more information
https://support.nureva.com/faqs-nureva-console/generate-enrollment-code-with- nureva-console-client
Enrolling an HDL410 onto the console:
enter your enrollment code (located at the bottom of the hardware).
You will be prompted to enter room level details – see next section.

HDL410 Room Level Settings

(room level settings)

Defining room type:
We are using a Meeting Room as an example.
Accessing room level settings
Your newly created room will appear in rooms section. Click [room name] for access.
Defining / editing the room dimensions: (Dual HDL410s work as if a single unit.)
Defining Room Dimensions for optimal performance: (Coverage map)
Measure your room and place HDL410 port 1 and 2 as precisely as possible.
In this demo, the actual room size is bigger than the defined dimensions. This helps to reduce eliminate echo and reduce background noise.
Fine tuning room in relation to seating arrangements and HDL410 ports:
The blue spots shows noise or voice detection.
Adjust your HDL410 port positioning as needed based on the environment and the room layout.
Recalibrating and optimizing the HDL410
Note: After enrolling and defining room level settings, click [Recalibrate]. This ensures all settings are stored and HDL410 “is aware” of environmental/room level changes. Whenever there are room level changes, please recalibrate your HDL410.

CamConnect Pro Settings

Link CamConnect Pro to HDL410

Enable HDL410 to send data to CamConnect.
Enter port [8931] & enter CamConnect Pro`s IP address [Ex. 192.168.11.11].

Please confirm that port 8931 is permitted to connect with your PC.

Go to [Supported Device & Settings] in CamConnect Pro’s HDMI/web interface.
- A. From the Device drop down list select HDL410.
- B. Enter HDL410`s IP address [example : Device IP = 192.168.11.27]. HDL410’s IP address can be found as shown in 3.1.
- C. Slide the toggle bar to connect.
Map and fine tune seating positions
In the Advanced settings of CamConnect Pro, set the Audio Trigger level to 65 or stay close to 60 depending on environment.
- CamConnect automatically provides 8 Azimuth Angles. These angles are adjustable to suit your space.
- Here we show only 4 azimuth Angles in operation. A voice source is detected at [-35 ~ -18 ] then the VC-TR40N camera’s preset 1 is used to frame the speaker sitting at that position.
- Map and adjust your azimuth angle and seating arrangements. Use the “heat map” in Coverage map as a guide.