ROUGH COUNTRY 921714000A Forged Upper Control Arms Owner’s Manual
- September 6, 2024
- Rough Country
Table of Contents
ROUGH COUNTRY 921714000A Forged Upper Control Arms Owner's Manual
KIT CONTENTS:
Driver Side Upper Control Arm x1 Pass Side Upper Control Arm x1
TOOLS NEEDED:
10mm Wrench or Socket
12mm Wrench or Socket
19mm Wrench or Socket
22mm Wrench or Socket
Phillips Bit Driver
HARDWARE INCLUDED:
Ball Joint Nuts x2
1/2″ Flat Washers x2
Torque Specs:
Size Grade 5 Grade 8 Size Class 8.8 Class 10.9
5/16” 15 ft/lbs 20ft/lbs 6MM 5ft/lbs 9ft/lbs
3/8” 30 ft/lbs 35ft/lbs 8MM 18ft/lbs 23ft/lbs
7/16” 45 ft/lbs 60ft/lbs 10MM 32ft/lbs 45ft/lbs
1/2” 65 ft/lbs 90ft/lbs 12MM 55ft/lbs 75ft/lbs
9/16” 95 ft/lbs 130ft/lbs 14MM 85ft/lbs 120ft/lbs
5/8” 135ft/lbs 175ft/lbs 16MM 130ft/lbs 165ft/lbs
3/4” 185ft/lbs 280ft/lbs 18MM 170ft/lbs 240ft/lbs
INSTALLATION INSTRUCTONS
POST INSTALLATION INSTRUCTIONS
- Check all fasteners for proper torque. Check to ensure for adequate clearance between all rotating, mobile, fixed, and heated members. Verify clearance between exhaust and brake lines, fuel lines, fuel tank, floor boards and wiring harness.
- Perform steering sweep to ensure front brake hoses have adequate slack and do not contact any rotating, mobile or heated members. Inspect rear brake hoses at full extension for adequate slack. Failure to perform hose check/ replacement may result in component failure.
- Activate four wheel drive system and check front hubs for engagement.
- Have a qualified alignment center align the vehicle immediately. Realign to factory specifications.
- Check and retighten wheels at 50 miles and again at 500 miles.
- All kit components must be retightened at 500 miles and then every three thousand miles after installation. Periodically check all hardware for tightness.
- Install “Warning to Driver” decal on sun visor
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>