ITIAN TECHNOLOGY MP08 Magnetic Power Bank User Manual
- August 30, 2024
- ITIAN TECHNOLOGY
Table of Contents
User Manual
Magnetic Power Bank
Model:MP08
MP08 Magnetic Power Bank
Thank you for purchasing and using this Product!
Please read this operation instruction carefully before using this product.
Attention
- Do not squeeze or collide vigorously.
- Please do not disassemble or put into the fire or water in the powered state to avoid short circuit and leakage.
- Please do not use In severe high temperature, high humidity or corrosive environment to avoid damage to the circuit and leakage.
- Please do not place magnetic cards with magnetc stripes or chips (ID cards, bank cards, etc.) on the wireless charging board to avoid magnetic card faiure
- Please do not place metal (coins and other metal objects) on the. wireless charging pad while charging, to avoid heat damage.
Product Detail Part
Specifications
| Battery Capacity | 5000rnAh /19.50Wh / 3.90V |
|---|---|
| Battery Type | Lithium Polymer Battery |
| Rated Capacity | 3000mAh (5V-2A) |
| Type C Input | 5V 2A / 9V 2A / 12V 1.5A |
| Type C Output | 5V 3A / 9V 2.22A / 12V 1.67A |
| Cell Phone Wireless Charging : | 10W(Max) |
| Operating Temperature | -10°C- 40°C |
Case Usage
FCC Requirement
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>