ITIAN TECHNOLOGY MP05 Magnetic Power Bank User Manual
- June 27, 2024
- ITIAN TECHNOLOGY
Table of Contents
ITIAN TECHNOLOGY MP05 Magnetic Power Bank
Thank you for purchasing and using this Product!
Please read this operation instruction carefully before using this product.
Attention
- Do not squeeze or collide vigorously.
- Please do not disassemble or put into the fire or water in the powered state to avoid short circuit and leakage.
- Please do not use in severe high temperature, high humidity or corrosive environment to avoid damage to the circuit and leakage.
- Please do not place magnetic cards with magnetic stripes or chips (ID cards, bank cards, etc.) on the wireless charging board to avoid magnetic card failure.
- Please do not place metal (coins and other metal objects) on the wireless charging pad while charging, to avoid heat damage.
Product Description
- 10000mAh battery capacity.
- Foldable 3 in 1 MagSafe Power Bank, convenient to storage on travelling.
- Fast wireless charging with 20W wired input and output.
- It solves the battery anxiety of the power bank. It can also charge the battery when used indoor on the desktop, and keep the rechargeable battery charged at all times when you are out.
Two Ways to Use
Desktop use
When using it on the desktop, prioritize fast charging for the phone and
watch, and switch to fast charging for the battery when the phone is 100% full
or when the phone is removed.
Please use a PD 20W adapter so that the charging will enter the fast charging mode.
Outdoor use
Solve rechargeable battery anxiety when using on the go, always have power
status.
Product Detail Part
Case Usage
Specifications
| Product Name | Magnetic Power Bank |
|---|---|
| Battery Capacity | 10000mAh /38.5Wh /3.85V |
| Battery Type | Lithium Polymer Battery |
| Rated Capacity | 6000mAh (5V=2A) |
| Type C Input | 5V=2A/9V=2A/12V=1.5A |
| Lightning Input | 5V=2A/9V=2A |
| Type C Output | 5V=3A/9V=2.22A/12V=1.67A |
| **Wireless Output** | Cell Phone Wireless Charging: 15W(Max) |
Watch Wireless Charging: 3W
Simultaneous Multi-Port Output| 5V=3A(Max)
Operating Temperature| -10″C-40″C
- For fast charging mode, 20W or above power adapter is required as its power source.
MADE IN CHINA
FCC Requirement
changes or modifications not expressly approved by the party responsible for
compliance could void the user’ s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interierence, and
- This device must accept any interierence received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>