Shenzhen Itian Technology F8 Wireless Charger User Guide
- June 5, 2024
- Shenzhen Itian Technology
Table of Contents
Wireless Charger
User Guide
Model-F8
Thank you for purchasing and using this product!
Please read this operation instructions carefully and keep it properly before
using this product.
Product Specification
Fast Wireless Charger
Input:5V— 2A/ 9V— 2A
Output:5W / 7.5W / 10W
Charging Efficiency:70%
Working frequency:110.5K-205K
Applicable Devices
MAGSAFE CHARGER
Apple Watch Charger
Tips: The attached Apple Watch charging cable is a gift, not original.
Original Apple Watch Charging Cable is recommended.
Please insert the attached apple watch charging cable into
the bottom USB port. This USB port is suitable for the apple watch charging
cable only, not for other devices’ power.
LED indicator light for iPhone
****White light: Standby
Blue light: Charging
Red light flash: Error
LED indicator light for AirPods
** White light: Charging
Below material is forbidden or affects the charging
efficiency.**
Adapter
Please use a PD adapter for fast charging The wireless charging can only be 5W
for the phone if choosing a 5V/1A adapter .
PU Silicone
Paste the bottom of the product, its advantage is not only can operate a
mobile phone with one hand but also not damage the wireless charger and
desktop.
The LED light turns red during wireless charging to
indicate a charging failure.
The following situation can cause failures, like charging slowly, stopping
charging, and over-temperature for charging position
- The adapter is not run up to standard.
- The charging cable is not up to standard.
- The phone case is too thick ( within 3mm thickness phone case recommended ).
- There is metal on the back of the cell phone or phone case. 5. Smartphone does not support wireless charging functions.
Attention
- Please keep the charger away from water or other liquid.
- If you need to clean the charger, please make sure it is not connected to the power supply.
- Using Environment temperature remains -20-45t.
FCC Requirement
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment This
device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
