Shenzhen Itian Technology K10 Wireless Fast Charger User Guide

Shenzhen Itian Technology K10 Wireless Fast Charger

Thanks for purchasing our product. Before getting started, please read the user manual carefully so as to ensure the proper operation and optimized performance of this product. Hope you have an enjoyable experience.

Product Introduction

This standing wireless charger with a simple design works with Ql standard mobile phones and devices. There is no plug on the charging devices, which is more convenient and efficient. The correct charging placement of mobile phone

Applicable Devices

Compatible with all devices with Qi Standard
All other mobiles without Qi Standard will be working with wireless receivers.
Instructions

1. Insert the USB side of the charging cable into the power adaptor, shown as below.
   Must use Qualcomm quick charge adaptor for fast wireless charging.

2. Insert another end of the USB charging cable into
   Type-C port to the wireless charger.

3. When the wireless charger connects with power, the LED light will flash on for a second to indicate the power on. Place the phone on the wireless charger and the light will turn off after 3 minutes to avoid lighting affecting sleep.
   When the LED light flashes during the wireless charging. which indicates a charging failure.

Standard Accessories

• Wireless Charger
• USB Cable
• User Guide

Product Specification

K10 fast wireless charger

• Input: 5V-2A/9V-1.67A
• Output:5V-1.5A/9V-1.2A
• Charging Efficiency: 75%

Attention

1. Please keep the charger away from water or other liquid.
2. If you need to clean the charger, please make sure it is not connected power supply.
3. Using Environment temperature remains -20-45C.

When the LED light flashes during the wireless charging, which indicates a charging failure.
The following situations can cause failures like the high temperature, slow charging, and no charging!

1. The adapter is not up to standard (No PC USB output power supply)
2. The charging cable is not up to standard;
3. The phone case is too thick (recommended phone case thickness within 2mm)
4. The phone is not placed at the center of the wireless charger
5. There is metal/magnet on the back of Cell phone or phone case.
6. Cell phones do not support Qi wireless charge function.

FCC Requirement

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>