Shenzhen Itian Technology S1 Wireless Car Charger User Guide

Shenzhen Itian Technology S1 Wireless Car Charger

Thank you for purchasing and using this product!
Please read this Operation Instruction carefully and keep it properly before using this product.
Product Specification
Fast Wireless Charger

• Input: 5V=2A/9V=1.67A
• Output: 5V=1.0A/9V=1.2A
• Charging Efficiency: 70%

Applicable Devices
Compatible with all devices with Qi Standard For all other mobiles without Qi Standard, those will be working with wireless receivers. The following situation can cause failures, like charging slowly, stopping charging, over- temperature for charging position.

1. The adapter is not run up to standard (No PC USS output power supply).
2. The charging cable is not up to standard.
3.  The phone case is too thick ( within 2mm thickness phone case recommended ).
4. The built-in wireless charging receiver position does not coincide with the wireless charger coil position.
5.  There is a metal/magnet on the back of the cell phone or phone case.
6. The smartphone does not support wireless charging functions.
   ! Attention

Support different sizes of smartphones let wireless charge.

Step to install air vent

 Press the button of the clip to fix, then adjust the angle and tighten

the fixed nut.

Step to Install Suction Cup

 Adjust the angle of the suction cup and empty air.

 Installation completed.

Step to Use wireless charger

1. Input: Connect the wireless charger and car adapter with the charging cord.
2. Must use Qualcomm quick charging adaptor for fast wireless charging.
3.  Place smartphone.

Tesla coil Sensor-wireless charger
Working Principle- After the Coil sensor detects the smartphone, it generates the current signal and then transmits the signal to the motor to drive the clip to close to tighten the smartphone.
Both sides of the clip open automatically after being powered, putting on the smartphone, clip close automatically to tighten the smartphone.

Take off the smartphone.

FCC Requirement
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
This device complies with Part 1 S of the FCC Rules. Operation is subject to the following two conditions: the  devicemayno1 causes harm ul I 1erfefence, and this device must accept any interference received, including ln1erfefence thal, may cause undesired operation.
Note: This equipment hu been tested and found to comply with the limits for a Class B digital device,  to Part 1S of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the inst ructions, may cause harmful inlerferenc::e to radio communications. However, there is no guarantee that interference will do not occur in a particular installation. If this equipment does cause harmful
interference to radioor1elevision reception, which can be later by1Ur ni ng the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following .

• Reorient or relocate their antenna.
•    increase the separation between the equipment and receiver.
• Connect the equipment into an outlet different from that to which the receiver is connected.
•  Coo sult the dealer or an experieoced radio/TVtech niciilnfor help.

LED indicator light shows the working status:

1. White LED Light Standby.
2.  Blue LED Light: Charging normally.
3.  Red LED Light: Charging abnormally.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>