Shenzhen Itian Technology Q9 Wireless Charger User Guide
- June 6, 2024
- Shenzhen Itian Technology
Table of Contents
Wireless Charger
User Guide
Model: Q9
About Magnet
This wireless charger is designed to attract magnetically, the iPhonel2 series mobile phone can be attracted instantly. Please use the Magsafe phone case for perfect attraction and wireless charging if you need a protective case.
Tips: Magsafe phone cases need to be purchased separately.
About adapter
The Max Output: Apple 7.5W, Samsung 10W. Please use the PD or QC 3.0 adapter.
The wireless charging can be 5W only if choosing a 5V2A adapter.
Tips: The PD/QC 3.0 adapter needs to be purchased separately.
About PU Flexible Glue
PU flexible glue is a kind of reusable and removable glue material. When PU flexible glue is dusty, it can be recycled after being cleaned and dried.
Product Specification
Fast Wireless Charger
- Input: 5V 2A/9V 1.67A /12V ****1.5A
- Output: 5V 1.0A/9V 1.20A
- Charging Efficiency: 70%
The LED light turns red during wireless charging o indicate a charging
failure.
The following situation can cause failures, like charging slowly, stopping
charging, and over-temperature for charging position.
- The adapter is not run up to standard (No PC USB output power supply).
- The charging cable is not up to standard.
- The phone case is too thick ( within 2mm thickness phone case recommended ).
- There is metal on the back of the cell phone or phone case. 5. Smartphone does not support wireless charging functions.
Attention
- Please keep the charger away from water or other liquid.
- If you need to clean the charger, please make sure it is not connected to the power supply.
- Using Environment temperature remains —20∼45°C.
MADE IN CHINA
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Statement
To maintain compliance with FCC’s RF exposure guidelines, This equipment
should be installed and operated at a minimum distance of 20cm from the
radiator of your body. This device and its antenna(s) must not be co-located
or operated in conjunction with any other antenna or transmitter