TigerTough E0822012 Single Seat Cover User Manual
- August 28, 2024
- TigerTough
Table of Contents
TigerTough E0822012 Single Seat Cover User Manual
Install Cover
Start with the seat back. Undo all the velcro tabs on the cover. Slide cover over the headrest.
The flaps at the bottom should be facing you.
Work the cover the rest of the way down the seat back.
Fit the cover around the switch, knob, and make sure it’s behind the lever on the side of the seat.
[View from back of seat]
Pull tabs tight and secure to velcro.
Fasten the three flaps under the headrest.
[View from back of seat]
Pull tabs tight and secure to velcro.
MISSION ACCOMPLISHED
Hey there!
It’s not rocket science, but following the instructions will make installing your seat covers a lot easier. We promise.
If you have any questions, comments, or issues, we’re here to help! You can reach us at 507.246.3545 (call or text) or email orders@tigertough.com.
PART NUMBER
PRODUCT TYPE
PIECES
E0822012
SINGLE SEAT COVER
(1) SEAT BACK
(1) SEAT BOTTOM
(1) HEADREST
LIFETIME WARRANTY
Basically, you break it, we buy it.
Seriously.
Your new seat covers are covered by an unconditional, no B.S. warranty.
That means that if you manage to abuse them to a point that they can’t perform
like they’re supposed to, we’ll make it right.
Depending on what is more practical, we’ll either repair or replace the
damaged cover.
This warranty only applies to the original purchaser.
General care instructions:
- In most cases dirt, debris, spills and pet hair can be removed by wiping with a damp cloth.
- Seat covers can be removed and machine washed on low temperature setting using mild detergent. Drip dry or machine tumble dry on a no heat cycle. Straps should be coiled and secured with rubber bands for machine washing and drying.
- Soil may be removed with spray cleaner or detergent and water.
- Oil or grease stains should first be treated with a dry cleaning solvent followed by a spray cleaner or detergent and water.
- Do not use bleach.