D-Link DWR-M930DS 4G Dual SIM LTE Router Installation Guide

D-Link DWR-M930DS 4G Dual SIM LTE Router

Product Information

Specifications:

• Model: DWR-M930DS
• Network: 4G LTE
• SIM Slots: Dual SIM (SIM 1 Active, SIM 2 Backup)
• Default Wi-Fi Network Name (SSID): D-LINK2G-XXXX
• Default Username: admin

Product Usage Instructions

SIM Card Installation:

The SIM card slot is located on the back of the router. Follow these steps to install the SIM card:

1. Insert the nano SIM card carefully with the gold contacts facing down.
2. Push the SIM card to lock it in place.

Power On:
Connect the DWR-M930DS to a power source using the included adapter. Press the power button until the device turns on.

Connect to Network:
Connect your device (laptop, computer, or smartphone) to the DWR-M930DS via Wi-Fi or Ethernet. Use the default Wi-Fi network name and password provided on the back of the router.

Access Router Settings:

Open a web browser and enter either https://192.168.0.1 or https://dlinkrouter.local in the address bar. Enter the default username and password to access the router settings.

Configure APN Settings:
If the connection isn’t automatically detected, manually configure the APN settings by navigating to the LTE tab and clicking on Basic Settings. Enter the correct APN information provided by your SIM card provider.

Technical Support Setup Procedure

How to Install

How to install DWR-M930DS 4G Dual SIM LTE Router

1. The SIM card slot is on the back, follow the slot’s diagram. Insert the nano SIM card carefully, ensure the gold contacts are facing down, and then push to lock it. (SIM 1 Active, SIM 2 Backup)
   Note: If the SIM is not in the device, not detected, or if no internet, the Globe LED (Red) will be displayed in front of the device.

2. Connect the DWR-M930DS to a power source using the included adapter. Press the power button until the device turns on.

3. Connect to your DWR-M930DS to either Wi-Fi or Ethernet using a laptop, computer, or smart phone). The default Wi-Fi network name (SSID) is D-LINK2G-XXXX, with the password printed on the back of your router.

4. Once connected, open a web browser and type in the address bar https://192.168.0.1 or https://dlinkrouter.local
   Note: In case you get a “Privacy Error”, click Advanced. Then, click Continue to 192.168.0.1 (unsafe) to proceed

5. You will be prompted to enter the username and password to access the router’s settings. The default username is admin and the password (printed on the label at the back of your router).
   Note: If you have changed the password and cannot remember it, you will need to reset the router to factory defaults.

6. Once logged in, you should see the DWR-M930DS’s web-based management interface. You will see a Signal indicator, Network Status: Connected and the WAN IP address indicates that the router is connected
   Note: Typically, routers automatically recognize the connection upon inserting the SIM card. However, if the connection isn’t detected, you can manually configure the APN Settings specific to your SIM card carrier.

7. To manually configure the APN settings, navigate through the LTE tab, and then click on Basic Settings from the left-hand menu. Enter the APN as required, then click Save & Apply. Remember to have the correct APN information, usually provided by your SIM card provider.

FAQ

Q: What should I do if I forget my router’s password?
A: If you have changed the password and cannot remember it, you will need to reset the router to factory defaults. This will reset the password to the default one printed on the label at the back of your router.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>