FIAMMA VW T5 Awning SWB Right Hand Drive Installation Guide
- July 30, 2024
- FIAMMA
Table of Contents
FIAMMA VW T5 Awning SWB Right Hand Drive
Specifications
- Product: VW T5 / T6 MULTIRAIL REIMO
- Model: 98655Z156
- Compatible with: F45s, F43van, FIAMMASTORE A 2x
- Dimensions:
- Upper Bracket: 100mm x 138mm
- Lower Bracket: 100mm x 138mm
FAQ
- Q: Can I install this product myself?
- A: It is recommended that the installation is carried out by qualified personnel to ensure proper alignment and compliance with regulations.
- Q: What should I do if I notice any damage during transport?
- A: Contact the dealer if you notice any damage or deformation of the product during transport.
PARTS AND TOOLS
FIAMMASTORE
Dimension
Installation instructions
Check that nothing has been damaged or deformed during transport.
In the event of doubts or questions concerning the installation, use or
limitations of the product, contact the dealer. We recommend that the
installation is carried out by qualified personnel and in compliance with
current local regulations.
ATTENTION: INSTALLATION ON FIXING KIT
F45s:The awnings are to be fixed on the brackets so that the words “SUPPORT”
on the awning are in correspondence of the brackets: this condition is
necessary and indispensable for the two brackets situated at the extremities
(which are located on the fixing point of the arms on the case-box). It is
important, but not indispensable, for the central bracket/s as it/they
provide/s only a mounting support.
The brackets must always be well-aligned to each other to avoid later
problems; in case they are not, they must be properly shimmed using the
spacers to ensure alignment.
The installation of the awning can occur only when the brackets are perfectly
aligned to the roof of the vehicle.
REAR and FRONT
Important: use of SIKA 252 adhesive is essential for fixing the bracket (brackets).
4 POSITIONS AVAILABLE
-
Position the bracket and awning so that they do not interfere with the side door.
-
Before tightening the screws, make sure that the awning position doesn’t prevent the opening of the rear door.
Safety instructions
4 POSITIONS AVAILABLE
-
Position the bracket and awning so that they do not interfere with the side door.
-
Carefully place the awning on the brackets, open it (taking great care as the awning is not fixed to the brackets) and lower the legs.
-
Before moving on to the next step, which consists in drilling the awning, check the positioning of the awning to allow to fully open the tailgate.
-
Position the template T on the inside of the case box, aligning it with the fixing bracket
-
O. Drill a ø 3 mm hole in the case box, taking care not to drill also the bracket of the specific installation kit.
LEFT AND RIGHT SIDE
-
Close the awning, remove it from the brackets and turn it around.
-
Enlarge the previously drilled holes (ø 3 mm) to ø 6.5 mm, taking care not to puncture the inner arms of the awning.
-
When using the awning please follow the instructions of the product.
-
ATTENTION Periodically check the brackets to make sure they are firmly attached (especially after the first kilometers) make sure the bolts are not loose and that holding brackets have not shifted.
Read the following instructions and warnings carefully; failure to observe these installation and usage instructions as well as the laws for driving in the relevant country may cause severe harm or damage for which the manufacturer declines all responsibility. Before installation, ensure compatibility with the vehicle on which the product must be installed. Checking that the wall/roof/rear door is sufficiently solid and suitable for guaranteeing the resistance of the anchoring points is always mandatory. If not, strength and compliance with the maximum load indicated in the instructions are not guaranteed and it will be necessary to reinforce it these points. In the event of an accident involving the vehicle and/or the product, ensure that the product has not been damaged. In the event of damage, contact your local retailer before moving the vehicle. Fiamma declines every responsibility for any modification of the product that may cause damage and/ or injury to things and people.
Warranty Fiamma
- In case of defects with regards to materials and manufacturing, the customer is entitled to the warranty in accordance with local laws and regulations of the country in which the product was purchased.
CONTACT
- Fiamma S.p.A. – Italy
- Via San Rocco, 56
- 21010 Cardano al Campo (VA)
- fiamma.com
Fiamma S.p.A.
reserves the right to modify at any time, without notice, prices, materials,
specifications and models or to cease production of any model.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>