strands 270716 Hi-LO Snow Plow Driving Light LED User Manual
- June 3, 2024
- Strands
Table of Contents
strands 270716 Hi-LO Snow Plow Driving Light LED
HI-LO SNOW PLOW DRIVING LIGHT LED
- BLACK = – TO CHASSIS GROUND
- RED = + HIGH BEAM
- WHITE = + AMBER POSITION LIGHT
- GREY = + WHITE POSITION LIGHT
- YELLOW = + LOW BEAM
- GREEN = + INDICATOR
The automatically heating lens provides maximum visibility in any weather. The feature is automatic, starts at 5 °C, and keeps snow and ice away from the lens – without any handling by the driver
Dimension
READ THIS BEFORE INSTALLATION
READ ALL INSTRUCTIONS AND STUDY DIAGRAMS BEFORE INSTALLING YOUR NEW LIGHTS!
LEGAL MOUNTING
Check with state or local authorities for laws governing usage and proper mounting of your new lights.
TAKE CARE OF YOUR PRODUCT
Keep the product clean. Dirt on the lens and heat-sink may shorten the products lifetime. We recommend using lukewarm water and alkaline degreasing. Follow the degreasing instructions carefully and rinse off gently with cold or lukewarm water on low pressure.
WARNING
Strong chemicals should not be used on the product. If you accidently get strong chemicals on the product, rinse off immediately, use plenty of water so that no chemicals remain in any joint. Some chemicals have a small amount of solvent in them, this can dissolve sealing adhesives and compromise the product’s waterproofness. Some chemicals pull out liquid from plastic and rubber-based components, which makes the plastic or rubber brittle and bursts more easily. Be careful not to use high water pressure close up on the product. If you use high water pressure at short distances, most products find it difficult to close out the water
INSTALLATION
If there is a contact/connector on the product, it should not be cutted. If the connector is cut, the warranty is not valid. If the product has loose cable and no connector. If the cable is shorter than 50 cm, the cable must not be cutted. If the cable is cut, the warranty is not valid. If the cable is longer than 50 cm, it is ok to shorten the cable, but not shorter than 50 cm. If the cable is cut shorter than 50 cm, the warranty is not valid. Tighten screws and bolts so that they do not loosen or chafe. Do not tighten screws so hard that the protective bearings on the product breaks
WARNING!
Do not use higher volts than the product description states. This light
becomes hot under continuous use. Don´t remove or touch the casing for at
least 30 minutes after turning the lamp off.
References
- Proffs på Fordonsbelysning & Lastbilstillbehör - Strands
- Proffs på Fordonsbelysning & Lastbilstillbehör - Strands
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>