strands ALASKA SNOW PLOW LAMP LED User Manual
- June 5, 2024
- Strands
Table of Contents
strands ALASKA SNOW PLOW LAMP LED
FEATURE
- Pin2 – RED = HIGH BEAM/HEATING LENS
- Pin1 – BLACK = – TO CHASSIS GROUND
- Pin6 – YELLOW = LOW BEAM/HEATING LENS
- Pin4 – GREY = INDICATOR
- Pin3 – GREEN = POSITION LIGHT
Alaska comes with a heating lens that provides maximum visibility in any weather. The feature is automatic, starts at five degrees and keeps snow and ice away from the lens – without any handling by the driver.
READ THIS BEFORE INSTALLATION
READ ALL INSTRUCTIONS AND STUDY DIAGRAMS BEFORE INSTALLING YOUR NEW LIGHTS!
LEGAL MOUNTING
Check with state or local authorities for laws governing usage and proper
mounting of your new lights.
TAKE CARE OF YOUR PRODUCT
Keep the product clean. Dirt on the lAens and heat-sink may shorten the
products lifetime. We recommend using lukewarm water and alkaline degreasing.
Follow the degreasing instructions carefully and rinse off gently with cold or
lukewarm water on low pressure.
WARNING!
Strong chemicals should not be used on the product. If you accidently get
strong chemicals on the product, rinse off immediately, use plenty of water so
that no chemicals remain in any joint. Some chemicals have a small amount of
solvent in them, this can dissolve sealing adhesives and compromise the
product’s waterproofness. Some chemicals pull out liquid from plastic and
rubber-based components, which makes the plastic or rubber brittle and bursts
more easily. Be careful not to use high water pressure close up on the
product. If you use high water pressure at short distances, most products find
it difficult to close out the water.
INSTALLATION
If there is a contact/connector on the product, it should not be cutted. If
the connector is cut, the warranty is not valid. If the product has loose
cable and no connector. If the cable is shorter than 50 cm, the cable must not
be cutted. If the cable is cut, the warranty is not valid. If the cable is
longer than 50 cm, it is ok to shorten the cable, but not shorter than 50 cm.
If the cable is cut shorter than 50 cm, the warranty is not valid. Tighten
screws and bolts so that they do not loosen or chafe. Do not tighten screws so
hard that the protective bearings on the product breaks.
WARNING!
Do not use higher volts than the product description states. This light
becomes hot under continuous use. Don´t remove or touch the casing for at
least 30 minutes after turning the lamp off. Contact us if you need support:
support@strands.se or +46(0)320-450450
References
- Proffs på Fordonsbelysning & Lastbilstillbehör - Strands
- Proffs på Fordonsbelysning & Lastbilstillbehör - Strands
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>