strands 809165 Dark Knight Identity 20 Inch LED Bar User Manual
- June 4, 2024
- Strands
Table of Contents
809165 Dark Knight Identity 20 Inch LED Bar
User Manual
809165 Dark Knight Identity 20 Inch LED Bar
RED = +VDC
BLACK = – TO CHASSIS GROUND
WHITE = WHITE POSITION LIGHT
YELLOW = AMBER POSITION LIGHT
READ THIS BEFORE INSTALLATION OR PAINTING
READ ALL INSTRUCTIONS AND STUDY DIAGRAMS BEFORE INSTALLING YOUR NEW LIGHTS!
LEGAL MOUNTING
Check with state or local authorities for laws governing usage and proper
mounting of your new lights.
TAKE CARE OF YOUR PRODUCT
Keep the product clean. Dirt on the lens and heat sink may shorten the
product’s lifetime.
We recommend using lukewarm water and alkaline degreasing.
Follow the degreasing instructions carefully and rinse off gently with cold or
lukewarm water at low pressure.
WARNING!
Strong chemicals should not be used on the product. If you accidentally get
strong chemicals on the product, rinse it off immediately, and use plenty of
water so that no chemicals remain in any joint.
Some chemicals have a small amount of solvent in them, this can dissolve
sealing adhesives and compromise the product’s waterproofness.
Some chemicals pull out liquid from plastic and rubber-based components, which
makes the plastic or rubber brittle and burst more easily.
Be careful not to use high water pressure close up on the product.
If you use high water pressure at short distances, most products find it
difficult to close out the water.
INSTALLATION
If there is a contact/connector on the product, it should not be cut. If the
connector is cut, the warranty is not valid.
If the product has a loose cable and no connector. If the cable is shorter
than 50 cm, the cable must not be cut. If the cable is cut, the warranty is
not valid.
If the cable is longer than 50 cm, it is ok to shorten the cable but not
shorter than 50 cm.
If the cable is cut shorter than 50 cm, the warranty is not valid.
Tighten screws and bolts so that they do not loosen or chafe.
Do not tighten screws so hard that the protective bearings on the product
break.
WARNING!
Do not use higher volts than the product description states.
This light becomes hot under continuous use. Don´t remove or touch the casing
for at least 30 minutes after turning the lamp off.
Contact us if you need support:
support@strands.se or
+46(0)320-450450www.strands.se
www.strandseurope.com
References
- Proffs på Fordonsbelysning & Lastbilstillbehör - Strands
- Proffs på Fordonsbelysning & Lastbilstillbehör - Strands
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>