DOSS SoundBox XL Ultra Wireless Home Speaker User Guide

August 21, 2024
Doss

Wireless Home Speaker Model No.: Soundbox XL Ultra
Quick Start Guide

Packing content

  • 1xSoundBox XL Ultra
  • 1xUSBC charging cable
  • 1x User Manual

Specifications

Output power: 20 2W+40W Subwoofer
Frequency response: 35H2-25ktHz
Signal to noise ratio 29508
DC power input: SV 3A/9v 2A
Battery: 11.1/4500mah
Charge time: ≈5 6hrs
Playtime: up to 18hrs (at 50% volume-0dB Pink noise] Bluetooth range: up to 30m/99ft
Unit net weight: 5.51bs/25ke
Unit dimension: 13.2
3.66.0 Inches/33592*152mm.
TF card and USB audio format: MP3/ WAV FLAC (Max capacity 2566)
Warranty: One- year limited

Important notes before using

  • To prolong the lifetime of the battery, fully charge the speaker before the Frst time using it
  • The battery is at a low level when the front indicator flashes red three times. every five minutes.
  • The speaker will automatically power off after 15 minutes without audio input
  • The front indicator will be OFF if there is no operation at the speaker within 30 seconds.
  • The USB out is only for playing audio.
  • When all buttons can’t be controlled, try to poke the Aux port with a paper clip.
  • If you need any assistance while using this speaker, please feel free to contact customer service at support@dossav.com.

Buttons and control

Buttons How to control Function
Press and hold 2s Turn on/off
Press Play/pause
Press Reconnect with the last device
+ Press and hold 2s Next track
Press Volume up
Press and hold 2s Previous track
Press Volume down
TWS Press and hold 2s Disconnect Bluetooth
Press Enter/ Exit TWS pairing
BASS•M Press and hold 2s Extra bass on/off
Press Change modes
Press and hold 2s
simultaneously Check version ID

(Only Works while Bluetooth disconnecting)
Tws• | Press and hold 2s simultaneously| Restore factory setting
BASS•M| Press and hold 2s simultaneously| Cancel/activate the auto power-off feature (Only works in Bluetooth mode)
–| Press and hold 2s simultaneously| Cancel/active the prompt tone
| Insert the charging cable| Charge the speaker
| Insert the USB drive| Play via USB drive
| Insert the Micro SD card| Play via Micro SD card
| Plug in the Line in cable| Play via Line in ( NOT included)

LED indication

| Flashing blue| Bluetooth pairing
---|---|---
Solid Blue| Bluetooth paired
Solid red| AUX mode
Solid green| TF card mode
Solid white| USB drive mode
Flashing green| Extra bass on
Flashing red| Extra bass off
Flashing green| Max volume
Flashing red every five minutes| Low battery level
| Solid red| Charging
Light off| Fully charged

Bluetooth mode

  1. Enable the Bluetooth feature on your device.
  2. Find “Soundbox XL Ultra” on the Bluetooth device and connect it.
  3. Once paired, you can see the status “connected” on your device.

TWS (True Wireless Stereo) mode

  1. Press the TWS. on both Soundbox XL Ultra to enter into TWS pairing.
  2. Once paired, the LED of the primary speaker turns solid blue, while the second speaker turns slowly flashing blue.
  3. Find ” Soundbox XL Ultra ” on your Bluetooth device and connect it.

Use your speaker with Echo Dot

You can connect the Dot with the speaker by Blustooth.
Please follow the steps o set up via Blustooth:

  1. Download the Alexa app and follow the standard setup procedure to get the dot connected to your home Wi-Fi network.
  2. Switch the Soundbox XL Ultra to Bluetooth mod.
  3. Run the Alexa App, tap Menu, and then tap Settings.
  4. Tap the Echo Dot n your st of Alexa devices, then tap Bluetooth.
  5. The Soundbox XL Kura should appear in the lst of Blustooth devices. If not, please long press the Bluetooth button and try t again.
  6. Once listed, tap on the speaker to complete the pairing process.
  7. To remove the device, return to Bluetooth > tap the name of speaker > tap “Forget Device””

Note:
Voice command will not be able to turn on/off the speaker if you connect to it via Bluetooth.

Safety instructions

  • Avoid dropping or hitting the speaker.
  •  Avoid exposing to extreme temperature.
  • Avoid using the speaker near a microwave.
  • Never disassemble or repair the speaker.
  • Never use any corrosive cleanser/oil to clean.
  • Never leave the speaker in a car parked in the sun.
  • Never attempt to charge the speaker while it is wet.

FCC Statement

“This equipment has been tested and found to comply with the limits for a Class Digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmul inter ference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, f not installed and used in accordance with the Instructions, may cause harmful interference to radio communications. However, there s no guarantee that interference will not occur in a particular installaton. I this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the useris encouraged totry to correct the interference by one or more of the following

  • Reorient or relocate the receiving antenna
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment This device complies with part 15 of the FCC Rules. Operation i subject to the following two conditions:

  1. This device may not cause harmful Interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Information
‘The device has been evaluated to meet general RF exposure requirement.
‘The device can be used in portable exposre condition without restriction.

ISED Statement

“This device contains licence-exempt transritter(s)receiver(s) that comply with Innovation, Science and Economic Development Canada’s icence-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.
    “This equipment should be installed and operated with minumum distance of 20 Ocmbetween the radiator and your body.

For updates, promotions, and experience sharing, join our customer community.

@dossav/ @dossfans
@dossdirect
www.dossaudio.com
1833:275.3677 Mo i AW SPMPT (USA)
Customer Service Email
US: support@dossav.com
UK: support_uk@dossav.com 

UK /REP
OST_UK _20220119000010
EVATOST CONSULTING LTD
Office 101 32 Threadneedle Street, London,
United Kingdom, EC2R 8AY
contact@evatost.com
We simply act as UK representative for cross-border sellers, and are not manufacturers/importers/distributors for the product, nor involved in the manufacture/import/sale of the product. Therefore, we are not responsible for any after-sales services related to the product. In case of any product quality or infringement issues, the manufacturer/importer/seller shall be solely held responsible.
EU /REP
OST EU 20220119000015
eVatmaster Consulting GmbH
Bettinastr. 30
60325 Frankfurt am Main,Germany
contact@evatmaster.com
We simply act as EU representative for cross-border sellers, and are not manufacturers/importers/distributors for the product, nor involved in the manufacture/import/sale of the product. Therefore, we are not responsible for any after-sales services related to the product.
In case of any product quality or infringement issues, the manufacturer/importer/seller shall be solely held responsible.
Wonders Technology Co.,Ltd

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals