84 855 Performance Floodlight BEGA UniLink Instruction Manual
- August 16, 2024
- BEGA
Table of Contents
84 855 Performance Floodlight BEGA UniLink Instruction Manual
84 855 Performance Floodlight BEGA UniLink
Safety
The installation and operation of this luminaire are subject to national safety regulations.
The manufacturer accepts no liability for damage caused by improper use or installation.
If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against
e. g. transients, etc. we recommend separate overvoltage protection components.
You can find them on our website at
Total load
When configuring your lighting system, please ensure that the maximum power consumption of 6 A is not exceeded. Information on power consumption can be found in the instructions for use and data sheets for all BEGA UniLink® luminaires.
Power consumption of 84 855: 0,2 A
Lamp
Module connected wattage 38.4 W
Luminaire connected wattage 42.5 W
Rated temperature ta = 25 °C
Ambient temperature ta max = 35 °C84 855 K3
Module designation LED-1020/830
Colour temperature 3000 K
Colour rendering index CRI > 80
Module luminous flux 6635 lm
Luminaire luminous flux 4361 lm Luminaire luminous efficiency 102,6 lm / W
84 855 K4
Module designation LED-1020/840
Colour temperature 4000 K
Colour rendering index CRI > 80
Module luminous flux 7005 lm
Luminaire luminous flux 4604 lm Luminaire luminous efficiency 108,3 lm / W
Lighting technology
Wide beam light distribution
Half beam angle 44°
Caution:
The BEGA UniLink® plug connectors may only be connected and disconnected in a voltage- free state.
Installation
Press the luminaire with earth spike vertically into the soil until stability is achieved. If necessary, compact soil around the earth spike.
Plug the floodlight’s connecting cable into the plug contact of the connecting cable with the country-specific mains plug, or into the distribution box or extension cable.
To ensure a sufficiently low protective conductor resistance (loop resistance), the connecting cable of each luminaire in the system must not exceed a length of 50 m from the entry point.
Adjustment of beam direction:
Undo joint screw (hexagon socket head wrench size 5 mm) and set the desired beam direction.
Tighten the joint screw.
Torque = 7 Nm.
Please note:
Do not remove the desiccant bag from the luminaire housing.
It is needed to remove residual moisture.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free
cleansers from dirt and deposits. Do not use high pressure cleaners.
Maintenance
The connecting cable must be checked for external damage and may only be replaced by a qualified electrician.
Replacing the LED module
The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted.
The module can be replaced by qualified
persons using standard tools.
Disconnect the system and open the luminaire. Please follow the installation instructions for the LED module.
Inspect and, if necessary, replace the luminaire
gaskets.
Defective glass must be replaced.
Close the luminaire.
Tighten grub screws (wrench size 3 mm)
evenly.
Torque = 2.5 Nm.
Accessories
0.5 m connecting cable with country-specificmains plugs 71 180 Plug type F
/ E: system common in Germany and Europe
71 181 Plug type G: system used in GreatBritain (“Commonwealth plug”)
1 182 Plug type J: system common in Switzerland and Liechtenstein
71 183 Plug type L: system common in Italy and Greece 71 184 Plug
type K: system common in Denmark and Greenland 71 186 BEGA UniLink®
Extension cable 5 m 71 187 BEGA UniLink® Extension cable 10 m 71 188
BEGA UniLink® Extension cable 20 m
71 247 Connecting cable 5 mwith free line ends 71 256 Connecting cable 0.5 mwith free line ends 71 189 BEGA UniLink® Five-way distributionboxFor the accessories a separate instructions
for use can be provided upon request.
Spares __
Spare glass with frame 25 000 145
LED power supply unit DEV-0131/850
LED module 3000 K LED-1020/830
LED module 4000 K LED-1020/840
Reflector 76 001 459 .A
Gasket 83 001 981
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>