MEAN WELL SE-1000 series 1000W Single Output Power Supply Owner’s Manual

August 14, 2024
MEAN WELL

MEAN WELL SE-1000 series 1000W Single Output Power Supply

FAQs

Q: What should I do if the power supply fails to turn on?

A: If the power supply fails to turn on, check the =following:

  • Ensure the AC input is connected properly and providing the correct voltage.
  • Verify that the power supply is securely mounted and all connections are tight.
  • If applicable, check for any blown fuses or tripped circuit breakers.
  • Contact customer support if the issue persists.

Features

  • AC input active surge current limiting
  • AC input range selected by switch
  • Protections: Short circuit / Overload / Over voltage Over temperature
  • Forced air cooling by built-in DC ball bearing fan
  • High power density 7.3w/inch®
  • With DC_OK signal output
  • Built-in remote ON-OFF control
  • Built-in remote sense function
  • UL / CUL approved
  • Low cost
  • 2 years warranty

GTIN CODE

SPECIFICATION

MEAN-WELL-SE-1000-series-1000W-Single-Output-Power-Supply-
fig-10MEAN-WELL-SE-1000
-series-1000W-Single-Output-Power-Supply-fig-11

Product Liability Disclaimer: For detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx.

Mechanical SpecificationMEAN-WELL-SE-1000-series-1000W-Single-Output-
Power-Supply-fig-3

TB1:AC input terminal

Pin No. Assignment
1 AC/L
2 AC/N
3 FG

TB2:110/220V Change

Pin No. 110V 220V
1 Short Open

2

Control Pin (CN3) : JST B6B-XH or equivalent

Pin No. Assignment Pin No. Assignment Mating Housing Terminal
1 DC_OK Signal 4 +S JST XHP

or equivalent

| JST SXH-001T

or equivalent

2| DC_OK GND| 5| RC-
3| -S| 6| RC+

Block Diagram

MEAN-WELL-SE-1000-series-1000W-Single-Output-Power-Supply-
fig-5

Derating CurveMEAN-WELL-SE-1000-series-1000W-Single-Output-Power-Supply-
fig-6

Static CharacteristicsMEAN-WELL-SE-1000-series-1000W-Single-Output-Power-
Supply-fig-7 Mechanical Specification

  • DC_OK Signal
    • DC_OK Signal is the voltage difference between “DC_OK” and “G” pin output
    • DC_OK Signal is a TTL-level signal
    • PSU turn on: 3.3 ~ 5.6V
    • PSU turn off: 0 ~ 1V

MEAN-WELL-SE-1000-series-1000W-Single-Output-Power-Supply-
fig-8

Remote Sensing

MEAN-WELL-SE-1000-series-1000W-Single-Output-Power-
Supply-fig-12

Remote Control

Between RC+ and RC- Output
SW OFF(0 ~ 0.8V) ON
SW ON(4 ~ 10V) OFF

MEAN-WELL-SE-1000-series-1000W-Single-Output-Power-Supply-
fig-9.

Downloaded from Arrow.com.

MEAN-WELL-SE-1000-series-1000W-Single-Output-Power-
Supply-1

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

MEAN WELL User Manuals

Related Manuals