BEGA 13340 Curved Metal Wall Shield Installation Guide

: August 14, 2024
: BEGA

Table of Contents

BEGA 13340 Curved Metal Wall Shield
Dimension
Instructions for use
Installation
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BEGA 13340 Curved Metal Wall Shield

Dimension

Wall shield for indoor use

Instructions for use

Application
A curved metal wall shield for colour-accentuating an individual luminaire on the wall, or for use in creative luminaire arrangements in groups or rows. Wall shield for complementary installation with BEGA ring wall luminaires.

Product description

Metal wall shield, curved, surface Colour velvet copper, for installation above the housing of a ring wall luminaire Ø 430 mm
Locking head made of synthetic material for screwing onto the threaded bolt of the wall shield
Mounting plate with locking bracket made of synthetic material
Two elongated mounting holes
Width 6 mm · 84 mm spacing
Alternative:
Two elongated mounting holes
Width 4.6 mm · Spacing 56 mm
Drilling template made of synthetic material enclosed
– Conformity mark
Weight: 0.7 kg

Safety
The manufacturer accepts no liability for damage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.

Please note: The installation of a wall panel should always be carried out after the installation of the luminaire.

Installation

Remove the curved wall shield, locking head and mounting plate with locking retainer from their packaging. Screw the locking head made of synthetic material clockwise and hand-tight onto the threaded bolt on the back of the wall shield with the flat side facing forward. To prevent damage to the surface, place the wall shield on a soft surface. Make sure that the mounting plate and locking retainer are precisely positioned for the installation of the wall shield. To do so, use the enclosed drilling template made of synthetic material.

Place the drilling template on the round luminaire housing. If necessary, a small spirit level may be placed on either of the flat sides of the drilling template. The tip of the drilling template can also be used to mark the position. Press the mounting plate into the central position of the drilling template at a right angle. Place the drilling template on the round luminaire housing according to the orientation of the luminaire.

IMPORTANT: Make sure that the concealed NYM cable is not damaged by the boreholes.

Once interlocked with the mounting plate, the drilling template can be rotated to allow alternative drilling of holes, adapted to the wall surface. The central position of the wall shield remains principally ensured. Mark the outer fastening points of the drilling template on the installation surface. Drill ∅ 6 mm holes in the installation surface and insert the dowels.

Remove the drilling template from the mounting plate. The drilling template is no longer needed and can be discarded. Screw the mounting plate onto the wall (outer elongated holes). Take the wall shield and slot it onto the luminaire housing from above (or from the side) behind the wall luminaire. The round cut-out in the wall shield defines its correct positioning. Slot the wall shield into the locking retainer of the mounting plate parallel to the wall by pressing on its middle.