CombiSteel 7292 Series Countertop Model Ice Cream Display User Manual
- June 3, 2024
- CombiSteel
Table of Contents
CombiSteel 7292 Series Countertop Model Ice Cream Display User Manual
CIRCUIT DIAGRAMS
NOTICE: These diagrams should be used comparing with the tags.
NON-TROUBLE PHENOMENON
| Phenomenon | Cause |
|---|---|
| Sound of liquid flowing or boiling | Normal sound of refrigerant in the |
pipeline, it may also happen when the compressor stops.
Sound of starting compressor| The motor sounds when the compressor works, the
sound will be louder when starting and stopping, which are normal phenomenon.
Moisture on the outside of the cabinet or surrounding the door.| When it is
rainy season or a humid day, there will be slight condensation, which is the
same reason why there are water drips on the outside of cold cups.
Extraordinary noise| Whether the ground is flat or the machine is stable or
not
Whether the dispenser touches the wall or other things
Strange smell in the cabinet| Whether the ice cream has gone bad
Whether the cabinet inner need to be cleaned
Compressor always working| If the temperature is not low enough, please check:
- Whether the wind path of the compartment is blocked.
- Whether the door is not closed tightly or the door is opened too frequently.
- Whether the ambient temperature is too high.
- If the inside temperature is too low and it is too hard for scooping, please adjust the electronic thermostat 1-2℃ higher(please refer to the temperature adjustment).
SAFETY CAUTIONS
Please read carefully and observe the following safety precautions.
The power outlet must be in accordance to the tag, and use a separate European
style socket (≥10A) and Plug. The sockets of the freezer should be connected
to stable ground wire.| The plug and the socket must be fastened together, or
it may cause fire. DO NOT crush or drag the plug, DO NOT damage the power
wire.
---|---
Putting inflammable and explosive dangers and serious acid-base things into
the cabinet prohibited. DO NOT use appliances inside the cabinet.| If there is
electricity leakage, abnormal noise, smells or smoke, please turn off power
and contact our aftersales service department.
You should install suitable automatic voltage regulator not less than 750w
when the voltage beyond the range from 187V to 242V.| Before renewing the
lamp, cleaning or maintaining the cabinet, or if you are not using the cabinet
for a long time, please pull out the plug.
If the power cord is damaged, do not use it, contact us immediately to change
for the new one in the appointed service point. DO NOT disassemble, maintain
or alter it by yourself.| DO NOT keep liquid food in glass bottles or pots, as
frozen glass may break. DO NOT touch the food and container in the cabinet
with your wet fingers in case your fingers are injured.
Once gas leaks, DO NOT touch the cabinet, shut the gas valve first, then open
the window letting the air in. DO NOT insert or pull out the plug of the
cabinet.| This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved.Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
Children aged from 3 to 8 years are allowed to load and unload refrigerating
appliances.
Since the flammable insulation blowing gases are used, please contact the
professional agent or our aftersales service to dispose of the appliance.|
Since the flammable refrigerants are used, please installed, handle, and
service the appliance strictly according to the instruction and contact the
professional agent or our aftersales service to dispose of the appliance
For appliances use flammable refrigerants, the information pertaining to the
handling, servicing and disposal of the appliance must be complied with.| If
the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.Children should
be supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons.| WARNING: When positioning
the appliance, ensure the supply cord is not trapped or damaged in order to
avoid a hazard.
WARNING: Do not locate multiple portable socket- outlets or portable
power supplies at the rear of the appliance.| WARNING: Keep clear of
obstruction all ventilation openings in the appliance enclosure or in the
structure for building-in.
WARNING: Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the manufacturer.|
WARNING: Do not damage the refrigerant circuit.
WARNING: Do not use electrical appliances inside the food/ice storage
compartments unless they are of the type recommended by the manufacturer.|
WARNING: In order to reduce flammability hazards the installation of this
appliance must only be carried out by a suitably qualified person.
Do not store explosive substances such as aerosol cans with a flammable
propellant in this appliance.| The symbol indicate there is risk of fire
since flammable materials used.
PREPARATION & INSTALLATION
- Remove all packing, including the foam base and the adhesive tape.
- Uplift the cabinet from bottom when moving it, do not lift or pull the door.
- When moving the cabinet, keep it upright, if it needs inclination, please lift it from both sides and the angle of inclination between the compartment body and the ground should be more than 45°.
- Please move carefully and avoid collision and shocking, in case damaging the appearance or breaking the refrigerating pipes.
- Keep the cabinet away from heat source, in a well-ventilated, dry place, out of sunshine.
- Put the cabinet on a solid and flat surface. If the ground is not level, the leveling legs can be adjusted to keep the cabinet level.
- Keep 100mm space surrounding the cabinet for heat dissipation.
- DO NOT put the cabinet in a wet or splash prone area, if there is splash please clean it with a soft cloth immediately.
OPERATING CAUTION
Do not put the ice cream in immediately after the freezer being plugged in, please put the ice cream in after the freezer has operated for about 1 hour
TEMPERATURE ADJUSTMENT
- The inner temperature will affect the temperature of the ice cream and the scooping. If the temperature is too low and it is hard to scoop, the temperature should be adjusted 1-2℃ higher by turning the thermostat (eg. from -29℃ to -27℃); if the temperature is too high and it is too soft for scooping, the temperature should be adjusted 1-2℃ lower (eg. from -27℃ to -29℃)
- The temperature displayed is the temperature of the air on the bottom of the cabinet, not the real temperature of the ice cream in the cabinet. The set number in thermostat is the lowest temperature on the bottom of the cabinet, the default temperature is -29℃.It would be best to set the temperature ranging from -27℃ to -29℃, if the temperature is too high it would be too soft for scooping, if the temperature is too low but the ambient temperature too high (higher than 38℃), the machine would work all the time.
- Setting of the electronic thermostat: press SET for 1-2 seconds, the set number would flash, then use the to increase and use the to reduce the temperature, finally press SET to confirm the new settings.
DEFROSTING
The cabinet needs to be defrosted by hand, after a long time of use, it will
frost on the interior liner, which will affect the refrigeration and increase
the power consumption. So when the ice gets thick, it should be defrosted
immediately. DO NOT use sharp or mechanical tools or electric heater to
defrost.
Turn off the power and open the door when you defrost. If you want to speed up
the defrosting, put a bowl of hot water (50℃) inside the cabinet. Turn on the
power after defrosting, then put the food in 1 hour later.
CABINET CLEANING
- Always unplug your cabinet before cleaning. Clean the cabinet with a warm wet wipe and some neutral detergent, then wipe down with a dry cloth. Do wipe off the greasy dirt on the plastic parts avoid the materials aging.
- DO NOT use hot water, harsh chemicals, soap, abrasives, petrol, thinner, alcohol, organic solvents or brushes.
- DO NOT wash machine with water directly in case of destroying the insulation.
- Check and dry the plug and power cords after cleaning the machine.
- Please use dry wipes when cleaning electric parts.
- The machine can be used after cleaning and getting the inside dried.
- Once power cut off, wait for at least 5 minutes before plugging in again to avoid damaging the compressor or the system.
PACKING LIST
Model 7292.0005 / 7292.0010 / 7292.0015 / 7292.0020
User manual 1x
Defrosting shovel 1x
This product will be continuously improved. We reserve the rights of changing the component of the cooler, without further notice, please accept our apologies.
TECHNICAL DATA
Model| Climate| Insulation| Power| Bulk| Rated|
Rated| Refrigerant
---|---|---|---|---|---|---|---
7292.0005
7292.0010
7292.0015
7292.0020| 4/N| I| 230V| 49| 180W| 1.3A| R290
These data are tested under standard conditions, if any changes, please refer to the tag, this information may alter without notice. The climatic class of the appliance is 4, it means that it can work in the ambient:
Dry bulb temperature °C| Relative humidity %| Dew point °C|
Water vapour mass in dry air g/kg
---|---|---|---
30| 55| 20| 14,8
DISPOSAL
Help protect the environment and human health. Put the packaging in applicable containers to recycle it. Help to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with this symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
