CombiSteel 7526.0100 Upright Glass Door Cooler User Manual

Upright Glass Door Cooler
7526.0100 – 7526.0105
7526.0110 – 7526.0115
User Manual

7526.0100 Upright Glass Door Cooler

Please read these instructions completely before operating the units.

SAFETY PRECAUTIONS

• To ensure proper use, please thoroughly study these SAFETY PRECAUTIONS before operating the unit.
• The purpose of the safety precautions in the manual is to ensure safe and correct use of the unit to minimize risks that could cause serious damage and injury to you or other persons. The safety precautions provided are divided into WARNINGS and CAUTIONS. Cases where improper handling of the unit could lead to death or serious injury are listed under the “WARNING” heading. However, the cases listed under the “CAUTION” heading could also lead to serious results. To ensure the safety, adhere strictly to both types of safety precautions.

WARNING
Improper handling of the unit could lead to death or serious injury.
CAUTION
Improper handling of the unit could lead to serious results depending on the circumstances.

• Text set off by the exclamation mark contains information that should be strictly adhered to.
• After reading the instruction manual, store it in an easily accessible place where the user(s) of this product can easily find it.

Precautions for installation
WARNING
Installation should be performed only by the dealer or a qualified expert. Attempting to install the unit yourself could result in water leakage, refrigerant leakage, electrical shock or fire.

Precautions for use
WARNING

All repairs, disassembly and modificationsshould be performed only by qualified technicians. Attempting to perform these yourself could result in a fire, malfunctionand injury. Never put flammable or volatile substances into the unit as explosion and fire could result. Never splash water directly onto the product or wash with water as shortcircuit and electrical leakage could result. Do not damage, modify, excessively bend, strain, twist or bundle up the power cord.
Also, placing heavy objects on the power cord or squeezing it into a tight place could damage it, possibly resulting in electrical shock or fire.

Use a dedicated wall outlet. Do not use extension cords or convenience receptacles as this could result in overheating, which could lead to fires oran electrical shock. The cooler is intended for storage and display of beer and beverages for sale. Do not use for other purpose than the intended as this could adversely affect items placed in the unit. For indoor use only. Using the unit in a location exposed to rain could result in electrical leakage and electrical shock. Install the unit in a location where the floor is sturdy enough to support the load of the unit. If the floor is not sturdy enough or installation is incorrectly performed, the unit could tip over and falling shelves and products could cause personal injury. Store the unit in a location where it is not exposed to rain. Using a unit that has been exposed to rain could result in electrical leakage and electrical shock. Never use flammable spray cans or leave flammable substances near the unit. Sparks from electrical switches could result in explosion and fire. Never attempt to insert fingers, sticks, etc. into the cold air suction outlet.
A circulation fan is rotating at high speed inside the outlet. Injury, electrical shock and improper operation could result. Never place heavy objects or items containing water on top of the unit.
Objects could fall down and cause injury and spilled water could deteriorate the insulation of electrical components and result in electrical leakage.

If you find gas leakage, please don’t touch the cooler. Close all gas valves and open the door(s) for ventilation. Gas leakage could cause explosion or start a fire which can cause a fire injury. Place the unit away from hot air sources.
The cooling performance will be reduced if the unit is placed near heat sources such as hot plates and stoves and if it is exposed to direct sunlight. Leave disassembly and disposal of the unit to qualified experts.

WELL VENTILATED PLACE
Please leave more than 10cm space between unit and the wall. If there is nspace, the cooling capacity will be reduced.

Never hang from the door or climb ontthe unit. The unit could tip over or fall and cause material damage or injury. Grasp the handle when closing the door.
Holding at other positions could result in pinched fingers and injury. When disconnecting the power cord plug from the wall outlet, hold at the plug main body close to the outlet. Pulling the cord could cause wire breakage, possible resulting in overheating and fire.

Do not throw items onto the shelves and do not place items totalling more than 30kg on each shelf. The shelf could fall down, possibly causing injury or break the shelf itself. Should the unit need temporary storage, make sure not to store the unit in a location where children play and take precautions so that the door(s) cannot be completely closed. This will minimize the risk that a child becomes trapped inside the compartment.
If installation in a damp location is unavoidable, please install an electrical leakage circuit breaker. If no electrical leakage circuit breaker is installed, electrical shock could result. Disconnect the power cord plug from the wall outlet before moving the unit and make sure that the power cord is not damaged during transport. A damaged power cord could result in electrical shock and/or fire.

Do not apply excessive force to the glass surfaces as the glass could break/smash and cause personal injury.

Make sure that the unit does not tip over or fall when it is moved. A falling unit could cause serious injury. Be sure to attach and secure shelves correctly. An improperly attached shelf could fall down and cause injury or break the shelf.

HOW TO USE

Before use

• Remove shipping package, tape, etc. Also leave the door(s) open for ventilation for a while.
• The unit is cleaned before shipment. However, clean the compartment interior once after delivery.
• Please insert power supply plug into the wall outlet, single-phase to cat voltage.
• Allow the unit to operate for about 1 hour to cool the compartment before placing items in the cooler.

WAIT 5 MINUTES OR MORE BEFORE RE-STARTING
Restarting the unit immediately after it has been turned off may cause fuses to blow and activate the circuitbreaker, thus, the compressor may be overloaded and/or other damage may occur.

Temperature adjustment
For showcase cooler, the interior temperature during fully loaded at factory default setting of position at 4-5 will be kept at 0-10°C. If the ambient temperature is extremely high or there is too much food inside the cooler, that might cause the interior temperature to be a bit higher. So, it would be better to turn the thermostat to the right so as to maintain the right temperature. On the opposite, if the ambient temperature is very low or there is less storage in the cooler, the interior temperature might be able to reach minus 0°C, and in return to cause the evaporator to ice up. Thus, it would be better to switch the thermostat to the left so the temperature can rise a little bit.

Drain tray

• Defrosting is performed automatically and drain water is collected in the drain tray.
• Water in the drain tray is evaporates automatically. In humid surroundings, there will be large amounts of water in the drain tray, so please throw away drain water at least once a day.

Efficient use
Please follow the instructions below, to save energy.

• To prevent cold air from escaping, open and close the door(s) quickly and keep the door(s) opened for as short a time as possible.
• Please install the unit in the place which is well-ventilated.

Shelf height adjustment
The shelf height can be adjusted. Arrange the shelves in accordance with the dimensions of the items to be placed in the cooler.

Placing items in the showcase
This showcase employs a forced circulation of cold air system. If circulation of cold air is obstructed, the items will not be adequately refrigerated. Pay attention to the following points:

• Do not let items obstruct the cold air inlet and suction outlet.
• Place items so that they do not protrude from the shelves. The gap between the shelves and the door(s) is used for circulation of cold air.
• Place items evenly on all shelves.
• Please do not display goods on the bottom. Please put goods on the shelf.

CLEANING

WARNING
To prevent any electrical shock hazards or injury by rotating circulation fan, always disconnect the power cord plug from the wall outlet before cleaning.
Exterior and cooler compartment
Wipe the exterior and cooler compartment of the unit with a soft, dry cloth. If very soiled, wipe with a cloth that has been moistened with a detergent. Then wipe with a cloth that has been dipped in water.
WARNING
Do not splash water directly onto the cooler and do not wash with water.
Short-circuiting and electrical shock could result.

• Clean the cooler regularly to keep it clean at all times.
• Never use polishing powder, soap powder, gasoline, oil or hot water as these will damage the painting and plastic components.

Checks after cleaning
To ensure the safety, perform the following checks after cleaning the unit.

• Make sure that the power plug is firmly inserted into a dedicated wall outlet. Confirm that the plug is not abnormally hot.
• Check the power cord for cracks and damage. Should the slightest irregularity be observed, contact thedealer form whom you have purchased the unit.

TROUBLESHOOTING

In case the unit shows operating problems, check the following before calling the authorized service agent.

connections.
Poor electrical power| Check the power connection and electrical outlet.
Thermostat set to the minimum position| Adjust the thermostat setting to a higher number.
Not reaching the desired
temperature| Unit is exposed to direct sunlight.| Relocate the unit to a shaded area.
Thermostat is not properly adjusted.| Adjust the thermostat setting to a higher number.
Door(s) not properly closed| Check the levelling of the unit and door seal.
Products poorly distributed or excess product load| Redistribute the product load according start instructions.
Clogged condenser| Clean the condenser.
Blocked grills| Clean the grills of any debris collected.
For models with electronic temperature controller, indicates EO or E1.| Unplug the unit from the outlet. If the error continues, contact an authorized service technician.
Excessive noise| The unit is not properly levelled.| Level the unit, making sure all the feet are in firm contact with the floor.
Something is in contact with the appliance, e.g. boxes, mops, brushes, etc.| Keep the objects away from the appliance.
Water on the floor| Drain hose is outside of the drain pan.| Lovate the hose in the drain pan.

www.combisteel.com

References

• CombiSteel

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>