Combisteel 7450.0316 Back Bar Cooler User Manual

Combisteel 7450.0316 Back Bar Cooler User Manual

SAFETY TIPS

• Position on a flat, stable surface.
• A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components or service panels on this product.
• Consult Local and National Standards to comply with the following:
  • Health and Safety at Work Legislation
  • BS EN Codes of Practice
  • Fire Precautions
  • IEE Wiring Regulations
  • Building Regulations
• DO NOT immerse in water or use steam/jet washers to clean the appliance.
• DO NOT cover the appliance when it is operating.
• DO NOT store food in the appliance.
• DO NOT use electrical appliances inside the appliance.
• Always carry, store and handle the appliance in a vertical position.
• Never tilt the appliance more than 45° from the vertical.
• Not suitable for outdoor use.
• Keep all packing away from children. Dispose of the packaging in accordance with the regulations of local authorities.
• If the power cord is damaged, it must be replaced by an agent or a recommended qualified technician in order to avoid a hazard.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Not for Foodstuffs.

INTRODUCTION

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your product.

PACK CONTENTS

The following is included:
ALL MODELS

• Back bar chiller
• Key
• Instruction manual
• 2 shelves per door

We pride ourselves on quality and service, ensuring that at the time of packing the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your dealer immediately.

INSTALLATION

Note: If the unit has not been stored or move in an upright position, let it stand upright for approximately 12 hours before operation. If in doubt allow to stand.

1. Remove the appliance from the packaging and the protective film from all surfaces.
2. Avoid positioning the appliance in direct sunlight or damp areas.
3. When positioning the appliance, maintain a distance of 20cm (7 inches) between the appliance and walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.
4. Insert the slide-out shelf/shelves at the desired levels and place the smaller shelf/shelves on the floor of the appliance.
5. If necessary, adjust the screw feet of the appliance to make it level.

Note: Before using the appliance for the first time, clean the shelves and interior with soapy water.

OPERATION

CONTROL PANEL
The control panel is located below the doors on the front of the appliance.

TURN ON

1. Close the door of the appliance.
2. Connect the appliance to a mains power supply.
3. Turn the light switches On [I] or Off [O] as desired.

Note: The cooling light is illuminated when the appliance is chilling the interior cabinet.

SET THE OPERATING TEMPERATURE

1. Press the button The display will flash.
2. Press the or buttons to display the required temperature.
3. Press the `` button to store the temperature.
   

MANUAL DEFROST
Back Bar Chillers feature an automatic defrost. However, should the appliance require an additional defrost period press and hold the button for 6 seconds.
Automatic defrost cycles are every 6 hours and last 20 minutes (factory defaults).
To stop the Defrost press and hold the button for 6 seconds.

Note: If a manual defrost is started this resets the automatic defrost timer. During defrost periods the defrost light is illuminated.

CLEANING, CARE & MAINTENANCE

• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Always wipe dry after cleaning.
• An agent or qualified technician must carry out repairs if required.

CLEANING THE CONDENSER
Periodically cleaning the condenser can extend the life of the appliance. We recommend that our agent or qualified technician clean the condenser.

Note: Use a soft brush or vacuum cleaner to clean the fins of the condenser, taking care not to damage the fins.

TROUBLESHOOTING

If your appliance develops a fault, please check the following table before making a call to your retailer.

plugged in correctly and switched on
Plug and lead are damaged| Call your agent or qualified technician
Fuse in the plug has blown| Replace the fuse
Power supply| Check power supply
Internal wiring fault| Call your agent or qualified technician
The appliance turns on, but the temperature is too high/low| Condenser blocked with dust| Call your agent or qualified technician
Doors/drawers are not shut properly| Check if doors/drawers are shut and seals are not damaged
Appliance is located near a heat source or air flow to the condenser is being interrupted| Move the refrigerator to a more suitable location
Ambient temperature is too high| Increase ventilation or move appliance to a cooler position
Insufficient airflow to the fans| Remove any blockages to the fan
Appliance is overloaded| Reduce the amount of food stored in the appliance
Factory default parameters adjusted| Call your agent or qualified technician
The appliance is unusually loud| The appliance is touching a neighboring object| Check installation position and change if necessary
The appliance has not been installed in level or stable position| Check installation position and change if necessary

ELECTRICAL WIRING

Appliances are supplied with a 3 pin, moulded, BS1363 plug and lead, with a 3 amp fuse as standard. The plug is to be connected to a suitable mains socket. Appliances are wired as follows:

• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E

All appliances must be earthed, using a dedicated earthing circuit. If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

DISPOSAL

EU regulations require refrigeration product to be disposed of by specialist companies who remove or recycle all gasses, metal and plastic components.
Consult your local waste collection authority regarding disposal of your appliance. Local authorities are not obliged to dispose of commercial refrigeration equipment but may be able to offer advice on how to dispose of the equipment locally.
Alternatively call the helpline for details of national disposal companies within the EU.

COMPLIANCE

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
Parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.

Products have been approved to carry the following symbol:

www.combisteel.com

References

• CombiSteel

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>