mgctech IC-W2 Watch Wireless Charger User Manual
- August 9, 2024
- MGCTECH
Table of Contents
User Manual
**Watch Wireless Charger
**
Product Features
- Apple Watch and Samsung Watch two-sided wireless charging, small and light, easy to carry.
- The i side can be charged directly on the Apple Watch, and the S side can be charged directly on the Samsung Watch.
- Only one type of watch can be placed for wireless charging per charge, and two watches cannot be charged at the same time
Specifications
Input: DC 5V/1A
Output: 2.5W
Charging Distance≤ 10mm
Charging Efficiency≤ 80%
Product Dimension: 34.611.534.6mm
Product Material: ABS+ Tempered Glass
Apple Watch charging | Samsung Watch charging |
---|---|
Attention
- Please do not vigorously extrude or collide.
- Please do not dismantle or put it into fire or water when the product is power on, to avoid short circuit or leakage.
- Please do not use it in severely high temperature, high humidity or corrosive environment, to avoid damage to the circuit leakage.
- Please do not put the magnetic strip or chip card (Such as ID card, bankcard etc.)on the charging pad to avoid to cause magnetic card lose efficacy.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radiofrequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The FCC certification of this device refers to RF exposure testing performed in typical operating conditions, where a person is no closer than 20 centimeters from the device surface at all times, except for non-repetitive patterns with transient time intervals in the order of a second. Only in the stated conditions, the device is shown to fully comply with the FCC RF Exposure requirements of KDB 447498.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>