MGCTECH IC-10C Wireless Charger User Manual
- June 15, 2024
- MGCTECH
Table of Contents
MGCTECH IC-10C Wireless Charger
Product Features
- Built-in magnet and wireless charging transmitter coil, placing the magnetic phone will automatically adsorption and start wireless charging.
- Standby mode : The RGB light running three laps and it keeps green.
- Charging mode : the ice blue breathing light keeps flashing.
- FOD function : when put metal or magnet objects on the charger, the ice blue light will flash for reminding. the wireless charging stops working
- Perfect protective function based on over-voltage, over-current, over-temperature and short-circuit protection.
Specifications
Input: DC 9V/2.5A, 9V/1.5A, 5V/1.5A
Output: 15W/10W/7.5W/5W
Product Standard: Qi
Charging Distance: < 10mm
Charging Efficiency: < 80%
Product Parts Description
Quick wireless charging requires QC or PD adapters.
Product Operating Guide
- Please make sure the product connect to the power before using.
- The green light keeps on if connected with power.
- The ice blue light will flashes and the product stop charging when the current is too large or there is foreign object. Do not wireless charging the phone if similar situation happened.
- Please purchase the wireless receiver module or case separately (Not included in the product) if your phone do not support wireless charging.
Attention
- Please do not vigorously extrude or collide.
- Please do not dismantle or put it into fire or water when the product is power on, to avoid short circuit or leakage.
- Please do not use it in severely high temperature, high humidity or corrosive environment, to avoid damage to the circuit leakage.
- Please do not put the magnetic strip or chip card (Such as ID card, bankcard etc.)on the charging pad to avoid to cause magnetic card lose efficacy.
- Please do not put the metal (Such as coin etc.) on the charging pad when charging, to avoid damage from heating.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance between 20cm the radiator your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>