MGCTECH SC-A3 Wireless Charger User Manual
- June 9, 2024
- MGCTECH
Table of Contents
Wireless Charger
User Manual
SC-A3 Wireless Charger
Fast wireless charging requires Qualcomm 18W or PD18W, and 18W above adapter
- Support wireless charging for iPhone
- Support wireless charging for Apple Watch and AirPods
Specifications
Input: DC 5V/3A DC 9V/3A Max
Output: DC 5V 0.4A/5V 1A/9V 1.22A/9V 1.66A
Product Standard：Qi
Rated power: Watch: 2W;
Earphone: 5W; Phone: 5W, 10W, 15W| Charging Distance：≤10mm
Charging Efficiency：≤80%
Product Dimension：146.735117.3mm
Product Material：ABS+Tempered Glass
Input interface：Type-C port
---|---
Indicators and Protection Function
- Standby mode: Indicator light keeps white and enters the standby mode.
- Charging mode: No indicator
- LED light: Press the button to adjust the brightness of the light.The white light will cycle from “weak, medium, strong and off ” in turn.
- Coil Indicator light: The ice blue light keeps on after 2 seconds of power-on.
- FOD function: When put metal or magnet objects on the charger, the white LED indicator light will flash 3 times for reminding.
- Perfect protective function based on over-voltage, over-current, over-temperature and short-circuit protection.
Attention
- Please do not vigorously extrude or collide.
- Please do not dismantle or put it into fire or water when the product is power on,to avoid short circuit or leakage.
- Please do not use it in severely high temperature,high humidity or corrosive environment, to avoid damage to the circuit leakage.
- Please do not put the magnetic strip or chip card (Such as ID card,bankcard etc.)on the charging pad to avoid to cause magneticcard lose efficacy.
- Please do not put the metal (Such as coin etc.) on the chargingpad when charging,to avoid damage from heating.
Note: This product is applicable to all Qi standard wireless charging phones,other phones need an external receiver for wireless charging function.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance between 20cm the radiator your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>