ETNA KIF5462ZT Induction Hob Installation Guide
- July 30, 2024
- ETNA
Table of Contents
Installation instructions
Induction hobs
KIF5462ZT Induction Hob
The fitting of the appliance should only be carried out by a registered and qualied installer. Please read the safety regulations.
Preparations for installation
Pictograms used Important information
Electrical connection
Free space around appliance
A (mm) | C (mm) | D (mm) |
---|---|---|
min. 500 | min. 760 | min. 50 |
This appliance must be earthed.
The electrical connection must comply with national and local regulations.
Connected load
| L1 (W)| L2 (1A/)| L3 (VV)| Total load (W)
---|---|---|---|---
KIF5462__| 3700| 3700| –| 7400
| A (mm)| B (mm)| C (mm)| D (mm)
---|---|---|---|---
KIF5462_| 590| 520| 49| 53
| A (mm)| B (mm)| C (mm)| D (mm)
---|---|---|---|---
KIF5462__| 560| 600| 490| 50
Placing sealing tape Electrical connection
By default, the power limiter is set to 7400 W. The user manual describes
how to set the power limiter.
When the appliance is used with 3500 W limitation, the mains cable may be
replaced by a 3 x 1.5mm (<2m) mains cable.
Ventilation If there is a drawer under the hob, it is necessary to x a
heat-resistant plate (90 °C) at a minimum distance of 15mm from the bottom of
the hob. You can find the most recent version of the installation instructions
on our website. * To reach the best hob performance, we advise a ventilation
gap as large as possible.
Do not install above a dishwasher.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>