ORTECH SLIM-RG2-5CCT LED Slim Lights Instruction Manual
- June 4, 2024
- Ortech
Table of Contents
ORTECH SLIM-RG2-5CCT LED Slim Lights
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
- LED Slim Lights are suitable for indoor use only. DO NOT use outdoors
- Please keep the LED Slim Lights away from any corrosive substance, and please use dry cloth when you clean them
- LED Slim Lights can only be installed by a qualified electrician
- Before installation or maintenance, please disconnect the power to prevent electric shock
Application Notice
- For your safety, this fixture MUST be wired in accordance to local electrical codes and ordinances
- Turn power off from the electrical panel before starting installation or attempting any maintenance. Indoor installation only
CAUTION
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR
FUTURE REFERENCES. Electrical products can cause death or injury, or damage to
property.
If in any doubt about the installation or use of this product, consult a
competent electrician.
INSTALLATION GUIDE
Tools Required
- Saw
- Measuring Tape
- Electrical Wiring (use type and gauge suitable for application to connect the fixtures)
Pre-installation
- Push the baffle on the module, then mount the rorund trim on the module (see Fig.1). Twist the trim to lock on the module securely
- Turn power OFF from the electrical panel before starting installation
- Locate a suitable position to plate the fixture and open in accordance to the cut-hole dimensions
- Run electrical wire from the switch (power supply) through the mounting hole — use NMD90 Romex or BX cable
Driver Wiring
- Open the hardwire box swing cover and remove the appropriate knockout(s)
- Insert the electrical supply cable through the knockout and secure with a cable connector (sold separately)
- Using wire nuts, connect GREEN ground wire of cable to GREEN wire on box. Connect WHITE wire of cable to WHITE wire of box. Connect BLACK wire of cable to BLACK wire of box (see Fig.2)
- Place all wiring and connections back into the box and close the cover
- Insert hardwire box through the mounting hole (see Fig.3).
New Construction Applications: Hardwire box shall be firmly secured to
studs, joists, or similar fixed structural units
Remodel Applications: DO NOT require the hardwire box to be firmly
secured after the mounting plates, studs, joists, or structural units have
been concealed 
Fixture Installation
- Connect light engine. Be sure to properly align connectors and fully screw down connector cover (see Fig.4)
- Connect the fixture to the hardwire box by inserting and twisting the male / female connectors (see Fig.5)
- Push spring loaded clips on the fixture upwards and insert fixture base into the mounting hole. Release the clips and fixture will be pulled flush to the ceiling (see Fig.6)
- Once assembly is complete, turn ON power to confirm that fixture is working properly
ORTECH reserves the right to modify at any time, without notice, any or all of
our product’s features, designs, components and specifications to meet market
changes.
info@ortechindustries.com
www.ortechindustries.com
13376 Comber Way Surrey BC V3W 5V9
375 Admiral Blvd Mississauga, ON L5T 2N1
1-888-543-6473
1-888-541-6474
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>