FLOS Emi Table and Floor Instruction Manual

: July 26, 2024
: FLOS

Table of Contents

Emi Table and Floor
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Emi Table & Floor

Emi Table and Floor

INSTRUCTIONS OF INSTALLATION AND USE ATTENTION!
The safety of the device can only be guaranteed on condition that to be respected the following instructions, both stages of installation and use therefore it is highly recommended to keep them.
WARNING:
To carry out the installation, and whenever an operation in the device is carried out, make sure of having disconnected the electric power.
The device cannot be in any case modified or forced, any modification might jeopardize the safety system making it dangerous. FLOS declines any responsibility on modified products.
The device has been designed for inside.
IP20 Ordinary.
Luminaires intended for direct assembly on surfaces that are normally flammable.
Class III luminaire: Device with a very low safety voltage. Connect the main cables to the remote led power supply SELV under the EN 61347-2-13 standard, respecting the right polarity (red positive black negative). Devices with a very low safety voltage showing the (BTS) mark should not be connected to earthing conductors.
Under no circumstances should the luminaire be covered with insulating or similar material.
If the flexible cable or cord of this luminaire is damaged, it should be exclusively replaced by the manufacturer or his technical service or a qualified person in order to avoid any risk.
The luminaire should only be used with Flos accessories or components.
The symbol shown on the device indicates that the product must be eliminated differently from the rest of the urban waste.
CLEANING INSTRUCTIONS
Use only a soft cloth to clean the appliance. For stubborn dirt, dampen the cloth with water and clean only the reflector and the outer part of the appliance. Do not clean or touch the LED/light source in any way. Warning: do not use alcohol or other solvents.
The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
Please refer to the product label to check the electrical specifications

| Replaceable (LED only) light source by a professional
---|---
| Replaceable control gear by an end-user

Use only original Flos accessories. Plugs included according to the version of the country.

WARNING! Handle with care WARNING! Don’t push the lamp Before switching on the lamp, screw the base to the body using the Allen key provided with the product. Make sure that the screws are securely tightened and the diffuser is flush with the body.
DEFAULT MODE ONE TOUCH When the lamp is switched off, pressing once on the rod will light it up to the last programmed intensity. When the lamp is on, pressing once on the rod will switch it off.
DEFAULT MODE HOLD PRESS When the lamp is switched on or off, holding down the up or down rod will increase the intensity until it reaches 100% and the light will flash twice. By releasing and holding down on the up or down rod again, the intensity will be reduced until it reaches 1% and the light will flash twice. ****

Erwan Bouroullec, 2024
flos.com