Xblitz R4 Power Car Adapter User Manual
- June 3, 2024
- Xblitz
Table of Contents
R4 Power Car Adapter User Manual
Xblitz R4 Power Hardwire Kit is a simple solution that allows you to connect any dashboard camera to use the mode Parking. The Xblitz R4 Power Hardwire Kit is compatible with 12V/24V DC power supply, so it can be used in cars and trucks.
INSTALLING THE XBLITZ R4 POWER KIT
- Connect the BLACK wire (GND) to the ground/ mass of the vehicle.
- Connect the RED wire depending on how you want to use your dashboard camera: a. Connect the RED wire to the ACC circuit so that the camera system starts automatical y when the engine is ignited. b. Connect the RED cable to the vehicle battery for the camera to record non-stop, 24/7.
The Xblitz R4 Power kit will automatical y stop your camera from over discharging your vehicle battery. If the voltage in the battery is too low, the Xblitz R4 Power wil stop powering your camera. You do not have to worry that your battery will be exhausted by the camera recording while the vehicle is parked. Set the voltage limit before the power cut-o for the camera according to the table below (the diagram may not correspond to your battery type)
TEMPERATURE| CAPACITY and VOLTAGE in 12V LEAD-AC:D ACCUMULATOR (in
volt al
---|---
°F| °C| 100%| 75%| 50%| 25%| 0
0| -18| 13.| 13.| 12.| 12.| 12.
10| -12| 13.| 13.| 12.| 12.| 12.
20| -7| 13.| 13.| 12.| 12.| 12.
30| -1| 13.| 13.| 12.| 12.| 12.
40| 4| 13.| 13.| 12336| 12.| 12.
50| 10| 13.| 13.| 12.| 12.| 12.
60| 16| 13.| 12.| 12.| 12.| 12.
70| 21| 13.| 12.| 12.| 12.| 12.
80| 27| 13.| 12.| 12.| 12.| 12.
90| 32| 13.| 12.| 12216| 12.| 12.
100| 38| 13.| 12.| 12.| 12.| 12.
110| 43| 13.| 12.| 12.| 12.| 12.
120| 49| 13.| 12.| 12.| 12.| 12.
130| 54| 13.| 12.| 12.| 12.| 12.
140| 60| 13.| 12306| 12096| 12.| 12.
FOR EXAMPLE: If the temperature of surroundings is 38 °C (100 °F) and you want to keep 50% of the battery capacity when the kit cuts o the power for the camera, you should set the kit so that the power is cut off when the battery voltage is 12.192 V. Set the battery protection switch to the 12.2 V setting. Only 50% of the battery capacity will be used on the car camera, even if you leave the car parked for a long time. If it is a 50Wh lead-acid battery, 50% of the capacity will allow for approximately 100 hours of camera recording. There are 4 protection settings in the Xblitz R4 Power. You can switch between them according to your needs:
- For 12V batteries, the protective settings are: 11.8 V/12.0 V/12.2 V/12.4 V.
- For 24V batteries, the protective settings are: 23.6 V/24.0 V/24.4 V/24.8 V.
The Xblitz R4 Power Kit automatically recognizes the lead-acid battery and will protect it from over-discharge. The 12.2 V/24.4 V setting is recommended for most users.
DEVICE SPECIFICATIONS
| Total cable length | 4 meters (input 1 meter, output 3 mete. s |
|---|---|
| Input cables | POWER/ GROUND |
| Input voltage | Normally DC 12/24V, Max. DC 36V, automatically detected. |
| Recom mended fuses for input cable | 2A 5×20 glass fuse or additional piggyback |
cable fuse
Output connector| Micro USB, DC 5V
Output current| Typically 1A, Max. 2A
Output capacity| Usually 5 W, Max. 10 W
Battery discharge protection| 11.8 V/12.0 V/12.2 V/12.4 V for 12V batteries
23.6 V/24.0 V/24.4 V/24.8 V for 24V batteries
Other security features| Protection from: reverse connection, short-circuit,
overheating, overcharging.
Operating temperature| -20 °C to 60 °C (-4 °F to 140 °F)
Control box Dimensions.| 4 Ox25x15 m m
A. The camera will always record, whether the vehicle is turned on or
parked:
B. The camera
will record while driving and will be disabled during parking.
WARRANTY CARD/COMPLAINTS
The product is covered by a 24-month warranty. The terms of the guarantee can be found at: https://xblitz.pl/warranty/ Complaints should be reported using the complaint form located at: http://reklamacje.kgktrade.pl/ Details, contact and website address can be found at: www.xblitz.pl Specifications and contents of the kit are subject to change without notice. We apologise for any inconvenience.
The crossed out trash can symbol indicates that unusable electrical or electronic devices, its accessories (such as power supplies, cords) or components (for example batteries, if included) cannot be disposed of alongside with household waste. In order to dispose of the devices or its components (for example, batteries) deliver the device to the collection point, where it will be accepted free of charge. Disposal is subject to the recast version of the WEEE Directive (2012/19 / EU) and the Directive on batteries and accumulators (2006/66 / EC). Proper disposal of the device prevents degradation of the natural environment. Information about the collection points of the facilities is issued by the competent local authorities. Incorrect disposal of waste is subject to penalties provided for by the law in force in the given area.
Manufacturer: KGK Trade sp. z o.o. sp. k. Ujastek 5B, 31-752 Cracow Poland Made in P.R.C.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>