Xblitz R5 Power Car Adapter User Manual

: June 3, 2024
: Xblitz

Table of Contents

Xblitz R5 Power Car Adapter
INSTALLATION
SETTINGS
PROTECTION FROM OVERHEATING
SAFETY MEASURES
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Xblitz R5 Power Car Adapter

Xblitz-R5-Power-Car-Adapter-User-Manual-product

Thank you for purchasing Xblitz R5 Power. This device is a power adapter, providing power for devices in your car, even when it is parked. The adapter is connected to the car’s battery with a piggyback fuse cable and provides power with 12/24V voltage. Please read the user’s manual before usage.

PACKAGE CONTENTS

Xblitz R5 Power
Fuses x4
Manual

INSTALLATION

Remove the fuse in your car’s fuse box and put it into the empty slot in the piggyback fuse cable (“original vehicle fuse” in the image).
Put the R5 Power piggy-back fuse cable into the now-empty slot in the fuse box.
Insert the stripping wire of the black cord into the GROUND terminal on the R5 Power body and lock the wire into place using the attached screwdriver; make sure no copper wiring is sticking out of the terminal
Insert the stripping wire of the red cord into the 12/24V positive terminal on R5 Power body and lock the wire into place using the attached screwdriver; make sure copper wiring is sticking out of the terminal; check the wiring again to avoid a short-circuit.
Attach the metal ring terminal from the black cord to a metal ground point on the body of the vehicle. Do not attach the ring terminal to a painted surface.
Insert the plug of the red cord into the receptacle of the piggyback fuse cable.
Press the power switch on R5 Power, and check if the Control light is on.
Seal the paired cartridge connector in place with tape, close the vehicle fuse
Fasten the parallel red and black cables to other vehicle cables with the use of cable ties.
Enjoy your purchase!

SETTINGS

Xblitz R5 Power has two settings you can configure to avoid over-discharging the vehicle’s battery when the vehicle is parked – Parking Timer Delay and Battery Drain Cut-Oj. R5 Power will cut the power supply to the connected devices oj based on whichever setting activates first. Parking Timer Delay can be set for m 5 minutes to infinity. In addition to the timer, you can set battery drain cut-oy voltage. As soon as your parked vehicle’s battery voltage drops to the set cut-0j value, R5 Power will stop powering your devices, saving your vehicle’s battery R5 Power will cut the power output oj at the end of the time set by the Parking Timer Delay setting, even if the battery voltage is still higher than the Battery Drain Cut-Oij setting.

R5 Power will cut the power output oj then the battery voltage drops to the value set by Battery Drain Cut-Oj setting, even if it the time set by Parking Timer Delay did not pass yet Thanks to those two settings, you never have to worry about your vehicle’s battery dying when your vehicle is parked.

PARKING TIMER DELAY SETTING DRAIN CUT-OFF SETTING

DEICE DESCRIPTION

Lighter socket (OUTPUT POW ER MAx 36 W)
Quick Charge port (OUTPUT PO WER MAX 24 W)
USB port (OUTPUT POWER 5V 2A)
Cut-dj voltage settings
Parking timer settings
Control light
Power switch

PROTECTION FROM OVERHEATING

R5 Power has a built-in temperature sensor, which measures the temperature of the wiring to protect R5 Power and your vehicle; if the wiring reaches a temperature above 90 C, R5 Power will automatically cut the power supply oğ; when the temperature falls beneath 90°C, R5 Power will automatically resume working.

PROTECTION FROM OVER-DISCHARGE
Please set the cut-or voltage value according to the temperature and how much of the battery’s capacity should be consumed before R5 Power cuts oj the powered output. Here is a chart for your reference (specifics may differ for dijerent batteries).

For example
If the environment temperature is 100’F (38’C) and assuming you want to keep 50 of your car’s battery capacity to remain when R5 Power cuts the output oj, you should set the device to cut power output oj at the 12.2V setting (i.e. above the 12.192 voltage fro m the chart). For a regular 50 Wh lead-acid battery, 50 of battery, consumption supports around 20 hours of dash camera recording. There are 4 protective band settings in R5 Power, which you can switch according to your needs: For a 12V battery, the voltage cut-oj settings are:

1.8V/12.0v/12.2V/12.4V
For a 24V battery, the voltage cut-oij settings are:
23.6V/24.0V/24.4V/24.8V
12.2V/24.4V band is recommended for most users in typical working conditions.

PIGGY-BACK FUSE TAP TYPE
The chosen fuse type is included in the kit.

SAFETY MEASURES

Do not install the device unless the car’s engine is turned on. The same is true for the disassembly of the device.
Do not use the device in a way that is against any laws of regulations of the region or country you are in.
Do not connect any devices that require a power supply different than 12/24V to the adapter.
Keep the device away from children
Do not expose the device to fire, extreme heat or extreme cold.
Do not put fingers or any other foreign objects into any of the device’s ports or sockets.
Do not damage the device.
Do not damage the wiring connecting the device and the car’s battery.
In case of a device malfunctioning, contact the blitz service point. Do not repair or maintain the device by yourself.

WARRANTY CARD/ COMPLAINTS
The product is covered by a 24-month warranty. The terms of the guarantee can be found at: https://xblitz.pl/warranty/ Complaints should be reported using the complaint form located at: http://rekla mache.kg trade.pl/ Details, Contact, and website address can be found at: www.xblitz.pl Specifications and contents of the kit are subject to change without notice. We apologize for any inconvenience.

The crossed-out trash can Symbol indicates that unusable electrical or electronic devices, their accessories (such as power supplies, and cords), or components (for example batteries, if included) cannot be disposed of alongside household waste. In order to dispose of the devices or its components (for example, batteries) deliver the device to the collection point, where it will be accepted free of charge. Disposal is subject to the recast version of the W EEE Directive (2012/19 / EU) and the Directive on batteries and accumulators (2006/66 degradation of the natural environment. Information about the collection points of the facilities is issued by the competent local authorities. Incorrect disposal of waste is subject to penalties provided for by the law in force in the given area. EC). Proper disposal of the device prevents.

Manufacturer: KGK Trade sp. z 0.0. sp. K.
Jacek 5B, 31-752 Cracow
Poland Made in P.R.C.