SHIMBOL TP Mini RX Wireless Video Transmission System Instruction Manual
- July 22, 2024
- Shimbol
Table of Contents
Wireless Video Transmission System
ITEM MODEL:TP Mini RX
Instruction Manual
Shenzhen ZO Video Technology Co.Ltd
01 /Features
Transmit Range Built-in Antenna Latency
UItra-low-Power Multiple Power Supply LED Display Status Light
02/Packing list
1 Receiver1
2 USB Power Cable1
3 User Manual*1
4 Sticker
03/Product Description
- LED Display Status Light
- Electric Quantity Button
- Pairing Button
- Power Switch
- HDMI Output(RX)
- HDMI Output(RX)
- USB Port
- Battery Plate
A. Press the 2 button to check the battery level, 4 green lights indicate the
battery level. When connected to USB, the green light is on.
B. The pairing button is production mode, and the client does not need to
pair.
04/Technical Parameters
| Receiver
---|---
Interface| HDMi output2
Power Supply Method| USB 5V/NP-F Battery
Power Consumption| 2W
HDMI input| /
HDMI Output| 720P@50/60Hz
1080P@24/25/30/50/60Hz
Weight| 113g
Size| 10363.5*16mm
Transmission Frequency Band | U-NI-1:5180MHz-5240MHz
U-NII-3:5745MHz-5825MHz
Transmit Power| 7mW/MHz
Transmission Delay| 70ms
Receiving Sensitivity| -85dBm
The TP Mini TX ‘s WIFI module working as A WIFI AP . When startup,
The AP will waiting for the TP Mini RX WIFI module [has been paired with TP
Mini TX in factory ]connecting.
When the connection established ,the TP Mini TX will send the video stream to
the TP Mini RX.
Tel:+860755-21004986
URL:www.zeroone-video.com
Address:2C,2nd Floor, Building 6,Longbi Industrial Park
No.27 Dafa Road, Bantian Street, Longgang District, Shenzhen
Shenzhen ZO Video Technology Co., Ltd.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/ TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. In order to avoid the possibility of exceeding the
FCC radio frequency exposure limits, Human proximity to the antenna shall not
be less than 20cm (8 inches) during normal operation.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>