HKS 48004-KB001 Circle Earth System User Guide
- June 4, 2024
- HKS
Table of Contents
2008 HYUNDAI GENESIS COUPE 2.0L TURBO
Part Number: 48004-KB001
Version: 01152009
48004-KB001 Circle Earth System
NOTICE
This manual assumes that you have and know how to use the tools and equipment
necessary to safely perform service operations on your vehicle. This manual
assumes that you are familiar with typical automotive systems and basic
service and repair procedures. Do not attempt to carry out the operations
shown in this manual unless these assumptions are correct. Always have access
to a factory repair manual. To avoid injury, follow the safety precautions
contained in the factory repair manual.
INSTALLATION PROCEDURE
-
REMOVAL OF FACTORY PARTS
(1) Disconnect the negative terminal from the battery -
INSTALLATION OF THE KIT
(1) Remove the bolt in section A, and temporarily install the Bracket. (Dia.1)
(2) Install the Circle Plate to the Bracket. Do not over-tighten the bolt. (Tightening Torque = 2.5-3.5 N-M / 0.25-0.35 kg-m) (Dia.1)
-
Verify the wire grounding positions for each wire in Diagram 2:
-
Install each wire as illustrated in Diagram 2.
ADVICE: Properly clean all wire connecting points.
**WARNING** Wiring must be done on the negative side only. Do not connect to the positive-side. -
Connect each wire to the Circle Plate with the provided kit parts. (Dia.2, 3)
-
Make sure each wire is secure.
-
Secure Wires 1 and 2 to the negative cable of the battery using the provided M8 Nut. (Dia.4)
-
Re-connect the negative battery cable to the battery.
-
Secure wires to the vehicle’s harness using the provided Tie-Wraps.
**CAUTION** When securing, re-routing or zip-tying wires, make sure that the Tie-Wraps do not get in the way of any moving parts (such as fans or belts). Otherwise, severe vehicle damage or fires can result. -
Install the Top Plate to the Circle Plate using the provided Bolt M3. (Dia.6)
CONFIRMATION AFTER INSTALLATION
Check the following after the installation process is complete.
（1）Check the following before starting the engine:
- Make sure pipes and hoses are routed and connected correctly.
- Make sure hose clamps are tightened.
- Make sure the negative cable terminal is securely attached to the battery.
- Make sure all bolts and nuts are tightened.
- Make sure all installed components do not come in contact with other parts.
（2）Start the engine and check the following:
- Make sure air is not leaking.
- Make sure RPM rises smoothly after revving the engine 2-3 times while in neutral.
- Make sure the installed parts are not hitting each other.
- Make sure no unusual conditions are found while idling.
MAINTENANCE
Proper maintenance of this product is necessary in order to maintain its
safety, reliability, and function of this product.
Maintenance is the responsibility of the driver/owner.
– If work needs to be performed outside the scope of this manual, consult a
professional.
– If the vehicle gets damaged, have the repairs performed by a professional.
– If you experience any abnormal noises, scents, or vibrations from the
vehicle while driving, reference the vehicle’s Owner’s Manual.
– If this product is ever re-sold, please give this Instruction Manual to the
new owner.
– When removing this product from the vehicle, please consult a professional.
PARTS LIST
E05251-B11010-00
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>