AOSYCO HTS-001 Hot Tub Steps with Storage Instruction Manual
- June 1, 2024
- AOSYCO
Table of Contents
TEST REPORT
HTS-001 Hot Tub Steps with Storage
Report No. :BJ-R231211104A-EN
Test Item :Load Bearing Test
Client :Nanjing Yosta Textile Technology Co.,Ltd.
Address :1 Kechuang Road, Yaohua Street, Qixia District, Nanjing City,
Jiangshu province. 210000
Inspected Engineer: Date Of Approval: Dec.15,2023
Date Of Approval: Date Of Approval: Dec.15,2023
Authorized Signatory: Date Of Approval: Dec.15,2023
Sample Information
| Sample Name | Hot Tub Step with Storage |
|---|---|
| Sample Model | HTS-001 |
| Trademark | AOSYCO |
| Sample No. | BJ-R231211104A-1#~2# |
| Sample Size | / |
| Weight Of Sample | / |
| Sample Quantity | 2 PCS |
| Manufacturer | Nanjing Yosta Textile Technology Co.,Ltd. |
| Address | 1 Kechuang Road, Yaohua Street, Qixia District, Nanjing City, |
Jiangshu province. 210000
Sample Source| Commissioned units send sample
Inspection Type| Commissioning test
Sample Description| Sample appearance is good
Test Results
| Test Items | **** Sample No. | Test Results | Requirement | Conclusion |
|---|---|---|---|---|
| Up | Down | |||
| Load Bearing Test | 1# | 1411.92 lbs | ||
| (6276.31 N) | 9206.83 lbs | |||
| (40929.29 N) | ≥3560N (800.32 lbs) | Pass | ||
| 2# | 4210.45 lbs | |||
| (18716.34 N) | 927.16 lbs (4121.44 N) | Pass |
Load Bearing Test
3.1 Laboratory Environment
Ambient temperature:25±3℃
Relative humidity:55±20%RH
3.2 Test Information
| Sample No. | Received Date | Date Of Test(s) |
|---|---|---|
| BJ-R231211104A-1#~2# | Dec.11,2023 | Dec.13,2023 |
3.2 Test Information
| Test Equipment | Equipment Model | Calibration Date |
|---|---|---|
| Compression Test Machine | BE-XL-5TS | Apr.13,2023 |
3.4 Test Standard
Test according to customer’s requirements.
3.5 Test Conditions
Test the load-bearing ultimate force values at the four specified local
positions on the step.
The local position is about the size of the foot.
Note: After installation, remember to check the fit and install all
modules in place.
3.6 Test Photos
Before test
Test setup
After test
Test curve
This report is considered invalidated without the Special Seal for Inspection
of the BTT. The customer is responsible for the accuracy, authenticity and
completeness of the sample(s) and information submitted by the customer, and
the company assumes no responsibility for it. This report is only responsible
for the result(s) of the sample(s) tested, andthe result(s) only reflect the
evaluation of the sample(s) tested. The result(s) in this report are used for
the purpose of corporate internal product research and development, quality
control,scientific research, teaching, etc.
This report shall not be copied partly without the written approval of BTT.
Any objections to report issued by BTT should be submitted to BTT within 30
days after the issuance of the test report.
Hotline
400-668-794