sunsky E-3562 Speaker User Manual
- July 11, 2024
- sunsky
Table of Contents
sunsky E-3562 Speaker
Product Accessories
- Speaker * 1
- Charging cable * 1
- Operation manual * 1
Product specification
| Product function | wireless/ TF Card /AUX/ USB drive/RGB |
|---|---|
| Effective distance | lOM |
| Output power | 5Wx2 |
| Charging voltage | USB SV |
| Power supply | Battery(1200mAh) |
| Frequency range | 100Hz-20KHz |
Functional diagram
Function instructions
-
On / Off
Power on: dial “on” / power off: dial “off” -
Wireless connection
After entering the wireless mode, search with your mobile phone or other devices, and conduct “S 19” pairing connection with the wireless device name. If you need to enter The input pairing code is 0000°, and enter the wireless playback mode after successful pairing. b. After the device is paired successfully, the next time the device enters the wireless mode, it will be automatically connected back to 10. After the connection back times out, it will enter the pairing state. -
TF Card / USB drive / AUX
Insert the TF card into the TF card slot and automatically switch to card reading mode. Insert the USB flash disk into the USB socket and automatically switch to the card reading mode. After connecting the aux frequency cable to the audio output device, insert the two ends of the cable into the interfaces of the output device and the speaker respectively, and then the audio can be played through the aux input. -
Key M: mode switching / RGB
Briefly press the M key to switch the playback mode, Long press the M key to switch the lights. -
Volume control / up / down switch
Short press the “+” key to increase the volume / long press one song to switch.
Short press the “-” key to decrease the volume / long press the previous song to switch. -
Charge Connect the USB plug of Type-C charging wire to the USB charging port with DC5V and connect the Type-C charging head to the DC5V socket on the machine to charge. The charging red indicator light is on and the charging light is off.
Warning :
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>