SUNSKY TV-Q02 Retro Desktop Lazy Live TV Phone Holder Instructions
- June 4, 2024
- sunsky
Table of Contents
SUNSKY TV-Q02 Retro Desktop Lazy Live TV Phone Holder Instructions
DESCRIPTION
- Working Range Effective 10m
- Working Time _?_6 Hours
- Loud Speaker Output : 5W
- Speaker : (0)52mm 40
- Distorion : 0.5%
- ignal-To-Noise : …90dB
- Frequency Response : 50Hz-22KHz
- Voltage Capacity : 1200mAH
- Charging Voltage : 5V±0.25V
- Charge Time : ElHours
- Net Weight : 450g
INSTALLATION
Handling instruction: Press and hold the power-on key to turn on the Bluetooth speaker,Find TV-Q02 and click Connect.
- Press and hold for 3 seconds to turn on the computer, and press and hold for a short time to switch the sound effects.
- Press the volume down for a long time, and press the previous song for a short time.
- Press once for pause/play, and press for seconds to disconnect Bluetooth.
- Press the volume for a long time, and press it once for the next song.
- Speaker charging port
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>