ThermoFisher SCIENTIFIC DT00358 Beam Width Illuminator Tool User Guide
- July 10, 2024
- ThermoFisher SCIENTIFIC
Table of Contents
DT00358 Beam Width Illuminator
Tool Use Document
DT00358 Beam Width Illuminator Tool
The world leader in serving science
Revisions
| Revision | Change Description | Changed By/Date |
|---|---|---|
| A | New Release | MK 04/03/24 |
Removing Packing Protection
1| Remove pink foam covering the LED.
2| Recommended to return this to protect the LED when not using the tool.
Accessing Board
1| Remove set screw from the housing.
2| Gently remove the cover of the housing.
Insert Batteries into Board
1| Locate positive and negative sides of the coin batteries.
2| Slide in the first battery with the positiveside up in the battery holder
on the board.
3| Carefully slide in the second battery on top of the first battery in the
same orientation (positive side up).
4| Make sure they are positioned in the battery holder correctly.
Place Board into Housing
1| Place cover back onto the board.
2| Tighten set screw to secure board within the housing.
Power On the Board
1| Use the micro screwdriver to move switch to turn board ON/OFF.
2| Ensure board is turned OFF when not in
use to save battery life.
Adjust Board Brightness
1| Use the same micro screwdriver to twist the potentiometer to adjust brightness of LED.
Remove Batteries from Board
1| Open casing following same instructions as Accessing Board.
2| Gently slide the board out of the casing.
3| Use the same micro screwdriver to gently push out the batteries one at a
time from the back.
4| Properly discard dead batteries.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>