Whirlpool 400011668910 Built In Dishwasher Instruction Manual
- June 1, 2024
- Whirlpool
Table of Contents
Whirlpool 400011668910 Built-In Dishwasher
Product Information
Specifications:
- Model : x2
- Power: 540W
- Dimensions: 537mm x 572mm x 538mm
- Temperature Range: 20°C – 345°C
- Capacity: 97 liters
Product Usage Instructions
Safety Instructions:
Before using the appliance, please read and observe the following safety instructions:
- Do not touch the oven during the pyrolytic cycle (self-cleaning) to avoid burns.
- Keep children and animals away during and after the pyrolytic cycle until the room is fully ventilated.
- Remove excess spillage, especially fats and oils, from the oven cavity before starting the pyrolytic cycle.
- Do not leave any accessory or material inside the oven cavity during the pyrolytic cycle.
- If the oven is installed below a hob, ensure all burners or electric hotplates are switched off during the pyrolytic cycle to prevent burns.
Installation:
When installing the appliance, follow these guidelines:
- The appliance must be handled and installed by two or more persons to prevent injury.
- Use protective gloves when unpacking and installing to avoid cuts.
- Complete all cabinet cutting works before fitting the appliance in the furniture and remove all wood chips and sawdust.
- Do not remove the appliance from its polystyrene foam base until the time of installation.
Electrical Warnings:
Regarding electrical safety, please adhere to the following instructions:
- The rating plate is located on the front edge of the oven and must be visible when the door is open.
- The appliance must be disconnectable from the power supply either by unplugging it or through a multi-pole switch installed upstream of the socket.
- The appliance must be earthed in conformity with national electrical safety standards.
FAQ
- Q: Can I use this appliance for professional purposes?
- A : No, this appliance is intended for household and similar applications only. Professional use is not permitted.
- Q: Is it safe to leave the appliance unattended during food drying?
- A: It is not recommended to leave the appliance unattended during food drying. Always exercise caution and ensure continuous supervision.
- Q: Can I store flammable substances near the appliance?
- A: No, do not store explosive or flammable substances inside or near the appliance to avoid the risk of fire.
SAFETY INSTRUCTIONS
IMPORTANT TO BE READ AND OBSERVED
- Before using the appliance, read these safety instructions. Keep them nearby for future reference.
- These instructions and the appliance itself provide important safety warnings, to be observed at all times. The manufacturer declines any liability for failure to observe these safety instructions, for inappropriate use of the appliance or for incorrect setting of controls.
- Do not touch the oven during the pyrolytic cycle (self-cleaning) – risk of burns. Keep children and animals away during and after the pyrolytic cycle (until the room has been fully ventilated). Excess spillage, especially fats and oils, must be removed from the oven cavity before initiating the pyrolytic cycle. Do not leave any accessory or material within the oven cavity during the pyrolitic cycle.
- If the oven is installed below a hob, make sure that all burners or electric hotplates are switched off during the pyrolytic cycle – risk of burns. Very young children (0-3 years) should be kept away from the appliance. Young children (3-8 years) should be kept away from the appliance unless continuously supervised. Children from 8 years old and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge can use this appliance only if they are supervised or have been given instructions on safe use and understand the hazards involved. Children must not play with the appliance. Cleaning and user maintenance must not be carried out by children without supervision.
- WARNING: The appliance and its accessible parts become hot during use. Care should be takento avoid touching heating elements. Children less than 8 years of age must be kept away unless continuously supervised.
- Never leave the appliance unattended during food drying. If the appliance is suitable for probe usage, only use a temperature probe recommended for this oven – risk of fire.
- Keep clothes or other flammable materials away from the appliance, until all the components have cooled down completely – risk of fire. Always be vigilant when cooking foods rich in fat, oil or when adding alcoholic beverages – risk of fire. Use oven gloves to remove pans and accessories. At the end of cooking, open the door with caution, allowing hot air or steam to escape gradually before accessing the cavity – risk of burns. Do not obstruct hot air vents at the front of the oven – risk of fire.
- Exercise caution when the oven door is in the open or down position, to avoid hitting the door.
DIMENSIONS
PERMITTED USE
MITTED USE
CAUTION : The appliance is not intended to be operated by means of an external switching device, such as a timer, or a separate remote-controlled system.
This appliance is intended to be used in households and similar applications such as: staff kitchen areas in shops, offices, and other working environments; farm houses; by clients in hotels, motels, bed & breakfasts and other residential environments.
No other use is permitted (e.g. heating rooms).
This appliance is not for professional use. Do not use the appliance outdoors.
Do not store explosive or flammable substances (e.g. gasoline or aerosol cans) inside or near the appliance – risk of fire.
INSTALLATION
- The appliance must be handled and installed by two or more persons – risk of injury. Use protective gloves to unpack and install – risk of cuts.
- Installation, including water supply (if any), electrical connections and repairs must be carried out by a qualified technician. Do not repair or replace any part of the appliance unless specifically stated in the user manual. Keep children away from the installation site. After unpacking the appliance, make sure that it has not been damaged during transport. In the event of problems, contact the dealer or your nearest After-sales Service. Once installed, packaging waste (plastic, styrofoam parts etc.) must be stored out of reach of children – risk of suffocation. The appliance must be disconnected from the power supply before any installation operation – risk of electrical shock.
- During installation, make sure the appliance does not damage the power cable – risk of fire or electrical shock. Only activate the appliance when the installation has been completed.
- Carry out all cabinet cutting works before fitting the appliance in the furniture and remove all wood chips and sawdust.
- Do not remove the appliance from its polystyrene foam base until the time of installation.
- After installation, the bottom of the appliance must no longer be accessible – risk of burn.
- Do not install the appliance behind a decorative door – risk of fire.
- If the appliance is installed under the worktop, do not obstruct the minimum gap between the worktop and the upper edge of the oven – risk of burns.
ELECTRICAL WARNINGS
The rating plate is on the front edge of the oven (visible when the door is open).
- It must be possible to disconnect the appliance from the power supply by unplugging it if the plug is accessible, or by a multi-pole switch installed upstream of the socket in accordance with the wiring rules and the appliance must be earthed in conformity with national electrical safety standards.
- Do not use extension leads, multiple sockets or adapters. The electrical components must not be accessible to the user after installation. Do not use the appliance when you are wet or barefoot.
- Do not operate this appliance if it has a damaged power cable or plug, if it is not working properly, or if it has been damaged or dropped.
- If the supply cord is damaged, it must be replaced with an identical one by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard – risk of electrical shock.
- If the power cable needs to be replaced, contact an authorized service center
CLEANING AND MAINTENANCE
WARNING : Ensure that the appliance is switched off and disconnected from
the power supply before performing any maintenance operation. To avoid risk of
personal injury use protective gloves (risk of laceration) and safety shoes
(risk of contusion); be sure to handle by two persons (reduce load); never use
steam cleaning equipment (risk of electric shock).
Non-professional repairs not authorized by the manufacturer could result in a
risk to health and safety, for which the manufacturer cannot be held liable.
Any defect or damage caused from non-professional repairs or maintenance will
not be covered by the guarantee, the terms of which are outlined in the
document delivered with the unit.
Do not use harsh abrasive cleaners or metal scrapers to clean the door glass
since they can scratch the surface, which may result in the shattering of the
glass.
Make sure the appliance has cooled down before cleaning or performing
maintenance – the risk of burns.
WARNING : Switch off the appliance before replacing the lamp – risk of
electric shock.
DISPOSAL OF PACKAGING MATERIALS
The packaging material is 100% recyclable and is marked with the recycle symbol . The various parts of the packaging must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal.
DISPOSAL OF HOUSEHOLD APPLIANCES
This appliance is manufactured with recyclable or reusable materials. Dispose
of it in accordance with local waste disposal regulations.
For further information on the treatment, recovery and recycling of household
electrical appliances, contact your local authority, the collection service
for household waste or the store where you purchased the appliance. This
appliance is marked in compliance with the European
Directive 2012/19/EU, Waste Electrical and Electronic Equipment (WEEE) and with the Waste Electrical and Electronic Equipment regulations2013 (as amended). By ensuring this product is disposed of correctly,
you will help prevent negative consequences for the environment and human health. The symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection center for the recycling of electrical and electronic equipment.
ENERGY SAVING TIPS
Only preheat the oven if specified in the cooking table or your recipe. Use
dark lacquered or enameled baking trays as they absorb heat better. Food
requiring prolonged cooking will continue to cook even once the oven is
switched off.
Standard cycle (PYRO): which is suitable for cleaning a very dirty oven.
Energy-saving cycle (PYRO EXPRESS/ECO) – only in some models -: which consumes
approximately 25% less energy than the standard cycle. Select it at regular
intervals (after cooking meat on 2 or 3 consecutive occasions).
Make sure the oven door is closed completely when the appliance is turned on
and keep it closed as much as possible while baking. Cut the food into small,
equally-sized pieces to reduce cooking time and save energy.
When the cooking time is long, over 30 minutes, reduce the oven temperature to
the lowest setting during the last phase (3-10 minutes), based on the overall
cooking time. The residual heat inside the oven will continue cooking the
food.
DECLARATIONS OF CONFORMITY
This appliance meets Ecodesign requirements of European Regulation 66/2014; Energy Labelling Regulation 65/2014; Ecodesign for EnergyRelated Products and Energy Information (Amendment) (EU Exit) Regulations 2019, in compliance with the European standard EN 60350- 1.
This product contains a light source of energy efficiency class G
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>