HANECO Platforma FG Highbay Cutting Edge Lighting Installation Guide
- July 8, 2024
- HANECO
Table of Contents
HANECO Platforma FG Highbay Cutting Edge Lighting
- Please read the instructions carefully before assembling and installation
- Please keep instructions as a reference in the future
Dimension
Installation Instructions
- Securely fasten the eyebolt to the body.
- To change the wattage settings, loosen the sealing cap using a spanner. Skip this step if you prefer to use the default output.
- Adjust the lighting level to your desired lumen output using the lumen select switches. If you’re using the default output, disregard this step.
- Securely tighten the sealing cap using a flat-head screwdriver. Disregard this step if you’re using the default output.
- Hang the luminaire by the suspension ring, attaching it to a fixed safety hook or closed link chain.
- Connect the wires as shown in the diagram to activate the light.
WARNING
- Ensure that any installation and maintenance are performed by a qualified electrician and the luminaire is wired under the local wiring and relevant Australian standards.
- Ensure that the power supply is off before starting installation and maintenance. Do not switch on until the installation or maintenance is completed.
- The light source of this luminaire is a non-user alternative light source, the light source contained in the luminaire shall only be replaced by the manufacturer of his service agent or a similar qualified person.
- Make sure the products are grounded.
- The power supply system should be equipped with SPD (Surge Protection Device) under electrical regulations.
- The products are suitable for indoor and semi-outdoor use with roof covers. It can be rinsed directly with water.
- For luminaires with dimmable LED drivers, reinforced insulation was provided between LV supply and the output/dimming circuit.
- The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than 3m is not expected.
CONTACT
- Haneco Lighting Australia Pty Ltd
- 262 Marion Road, Netley, South Australia 5037
- Haneco.com.au
- 1300 001 533
- OSRAM is a trademark of OSRAM GmbH.
- TRAXON is a licensee of product trademark OSRAM for a fixed list of General Lighting products.
- Haneco Lighting Australia is a Traxon distributor of OSRAM products in Australia, New Zealand, and the Pacific Islands.
OSRAM OFFICIAL LICENSEE
- Traxon Technology Ltd.
- 213 Wireless Centre,
- 3 Science Park East Avenue,
- Science Park, Shatin,
- New Territories, Hong Kong
- Phone: +852 2943 3488
- www.traxon-ecue.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>