HANECO OVL14W145R OVOLO LED Downlight Installation Guide
- October 27, 2023
- HANECO
Table of Contents
HANECO LIGHTING LED DOWNLIGHT INSTALLATION GUIDE
OVOLO
Installation Guide
OVL14W145R OVOLO LED Downlight
Thanks for choosing our surface mount OVOLO products.
We strongly recommend that you read this manual carefully before installation.
| IC-4
Suitable for residential or commercial use.
Fitting can be covered with building insulation.
Can be used where air transfer is not permitted or not desired betweed living
space & roof space.
---|---
| Do
not cover
Suitable for residential or commercial use in AU. Fitting cannot be covered
with building insulation. Insulation must be placed as per clearance distances
according to manufactures installation guide.
Installation Instructions
- Cut a hole in the ceiling according to the table below:
PRODUCT CODE| CUT-OUT| HEIGHT| FACE DIAMETER| IC RATING ta25°
---|---|---|---|---
OVL14W145R| 120mm| 61mm| 143mm| IC-4
OVL18W165R| 135mm| 63mm| 165mm| IC-4
OVL20W200R| 162mm| 68mm| 200mm| DO NOT COVER
OVL30W230R| 195mm| 75mm| 230mm| DO NOT COVER - Select CCT and power settings.
- Insert plug and cable through the cut-out into the ceiling cavity and plug into a pre-wired socket outlet inside the ceiling.
- Fold mounting clips up to the sides of the luminaire and insert luminaire through the cut-out. The mounting clips will retract onto the rear face of the ceiling and hold the luminaire in position.
- Insulation cannot abut and cover the luminaire.
WARNING:
If the external flexible cord of this luminaire is damaged, it shall be
exclusively replaced by the manufacturer or by a service agent or licenced
electrician in order to avoid a hazard.
Non-user replaceable light source. The light source contained in this
luminaire shall only be replaced by the manufacturer or by a service agent or
licenced electrician.
The diffuser is integral to the luminaire and cannot be removed without being
permanently damaged.
WARNING
The luminaire must be installed by professional electrician.
Switch power off when wiring the luminaire.
Ensure input voltage conforms to the voltage range of product.
Ensure wires are securely connected.
Before switching on, ensure that all the wiring is correct.
The warranty is void if product is not installed according to the
instructions.
Product Code: OVL14W145R
OVL18W165R
OVL20W200R
OVL30W230R
For more information
www.haneco.com.au
1300 001 LED (533)