HANECO CEDAR LED Commercial Downlight Installation Guide
- June 9, 2024
- HANECO
Table of Contents
HANECO CEDAR LED Commercial Downlight
Thank you for choosing Haneco CEDAR LED downlight.
We strongly recommend that you read this manual carefully before installation.
WARNING
- Installation must be carried out by a licenced electrician and in accordance with these instructions and relevant Australian standards and local regulations.
- Ensure input voltage conforms within product specifications.
- Ensure wires are securely connected.
- Before switching on, ensure all wires are correctly connected.
Do not cover
Suitable for residential or
commercial use in AU.
Fitting cannot be covered with building insulation.
Insulation must be placed as per clearance distances according to manufactures
installation guide
Specifications
Model| Cut-Out| Adjustable Angle| Dimmability| IC Rating ta25°C| IP Rating|
Operating Temp
---|---|---|---|---|---|---
D38W195R4K60DF| Ø165mm| 60°| Non-Dimmable| Do not Cover| IP20| -20 to 50°C
Installation Instructions
-
Switch off power
-
Cut the Ø165mm hole on the ceiling
-
Insert plug and cable through the cut-out into the ceiling cavity and plug into a pre-wired socket outlet inside the ceiling.
-
Fold mounting clips up to the sides of the luminaire and insert luminaire through the cut-out.
-
Ensure insulation do not abut and cover the luminaire
-
Switch on power
Dimension
a: 100mm,b:100mm,c:50mm There is minimum 100mm of free space around and 50mm above the luminaire
Class II Solid Earthed Fitting
Note: Product technical information and specification may change over
time without prior notice. For latest information, please contact our customer
service or visit our website
www.haneco.com.au
CUSTOMER SUPPORT
PRODUCT CODE: D38W195R4K60DF
For more information
www.haneco.com.au
(08) 8297 6373